Carrier Foretrack V100 User manual

Carrier Foretrack 5m Antenna Replacement V1.3
Carrier Foretrack
1.
Disconnect the power cable
old GPRS antenna connections from the DataCOLD 500 recorder
through the grommet.
2. Locate
the GPRS antenna
location at the top of the refrigeration unit
from the refrigeration unit
Then refit the new antenna
Securely fit the Connection box in the same area (examples above).
3.
Securely screw together the brass connections inside the box following the
correct colour coding (do not over tighten) and fit the box
supplied ensuring that the seal is correctly located.
Cont…….
Page 1 of 2
Carrier Foretrack
–
5m Antenna Replacement
Disconnect the power cable
from the Carrier Foretrack V100
and r
old GPRS antenna connections from the DataCOLD 500 recorder
the GPRS antenna
usually fitted in the highest most
convenient
location at the top of the refrigeration unit
. Remove the antenna and its cable
from the refrigeration unit
.
Then refit the new antenna
using the supplied adhesive pad.
Securely fit the Connection box in the same area (examples above).
Securely screw together the brass connections inside the box following the
correct colour coding (do not over tighten) and fit the box
lid using the screws
supplied ensuring that the seal is correctly located.
23/04/2013
5m Antenna Replacement
V1.3
and r
emove the
old GPRS antenna connections from the DataCOLD 500 recorder
and out
convenient
. Remove the antenna and its cable
Securely fit the Connection box in the same area (examples above).
Securely screw together the brass connections inside the box following the
lid using the screws

Carrier Foretrack 5m Antenna Replacement V1.3
4. Route the cables back
through the unit frame
secure as needed.
R
oute the cables into the DC 500 and c
Carrier Foretrack V100
5.
Check operation of the DataCOLD 500 including unit communication by
pressing the RED
status button.
the display (If none
present check all connections and Micro configurations
before proceeding further).
Page 2 of 2
through the unit frame
of the unit
to the DC 500 and
oute the cables into the DC 500 and c
onnect the new
antenna cables to the
Check operation of the DataCOLD 500 including unit communication by
status button.
Check that there is a valid Setpoint shown in
present check all connections and Micro configurations
before proceeding further).

Note:
In the
communication process the arrow
display, during this time the keypad will be temporarily locked.
23/04/2013
to the DC 500 and
antenna cables to the
Check operation of the DataCOLD 500 including unit communication by
Check that there is a valid Setpoint shown in
present check all connections and Micro configurations
communication process the arrow
will appear on the
display, during this time the keypad will be temporarily locked.