Casetronic Engineering Group Travla Series Setup guide

Travla Series
Model : C138
4" x 8" x 8.5" (HxWxL)
QUICK START
USER GUIDE
Index
1) Remove Top Cover
2) Remove Component Holder
3) Install Memory
4) Install Slim Hard Drive
5) Install 3.5" HDD to Component Holder
6) Install CD-ROM to Component Holder
7) Install Motherboard
8) Install Riser Card
Copyright © 2003-2005 Casetronic Engineering Group
Front Connectors
Microphone
Speaker
Power Switch
Power LED
HDD LED
A B C D
A. M3x8mm SocketScrew
C. CD-ROM Screw
B. M3x5mm Flathead Screw
Screw Idenfication Guide
D. M3 Captive Fastener
8mm 3mm 5mm
5mm
E
E. Hex Washer Screw
WARNING:Installation and service to
this product should only be performed
by qualified personnel to avoid risk of
injuries and damage to this product.
Rear Connectors
PS/2 Mouse
PS/2 Keyboard
VGA port
USB ports
10/100 Ethernet
Serial Port
Parallel port
S-Video port
RCA port Mic In
Line In
Line Out
DC power jack
Optional 1394 & USB
8mm
USB 2.0
Distribue par Anteor - www.anteor.com - Tel : [phone]

2
1.
1. Loosen screws "D" (x2)
2. Slide out Top Cover
1. Remove Top Cover
Copyright © 2003-2005 Casetronic Engineering Group
Remove Component Holder
2.
3.
Install Memory
3.
1. Push the white retaining latches at both
ends of the DIMM slot outwards.
2. Press the memory module down into the
DIMM slot until the retaining latches rotate up.
1. Remove screws "B" (x2)
Install Slim Hard Drive
4.
1. Attach Slim Hard Drive to the side
2. Install screws "B" (x4)
2. Remove screws "E" (x4)
D
D
Slim HDD
E
E
E
E
B
B
BB
B
B
Install Motherboard
7.
1
Install Riser Card
8.
For more information on the DC to DC converter, please visit www.DC2DC.com
1. Remove the Component Holder
2. Install the Riser Card and PCI card if applicable
1. Install motherboard from top
2. Install screws "E" (x4)
Riser Card
Copyright © 2003-2005 Casetronic Engineering Group
E
E
E
E
For more information to this product, please visit www.TRAVLA.com
Install 3.5" HDD to Component Holder
5.
1. Place CD-ROM in component holder
2. Install screws "C" (3x)
3. Install Component Holder back into the case
1. Place HDD underneath component holder
2. Install screws "B" (4x)
C
C
C
Install CD-ROM to Component Holder
6.
CD-ROM
3.5" HDD
B
BB
B
* Note: The expansion slot is not available
when standard 3.5" HDD is installed.
Distribue par Anteor - www.anteor.com - Tel : [phone]