Cebekit C-0221B User manual

WIND GENERATOR
WITH SOLAR MOTOR
C-0221B
A Pedestal with integrated photovoltaic cell 1 piece
B Column 1 piece
C Motor housing (gondola) and rotor blade holder 1 piece
D Blades 3 piece
E Rotor Cover 1 piece
NO GLUE OR TOOLS NEEDED
BOX CONTENTS
All small parts can be found within the pedestal To
remove them, turn the stand down, press the nail of the
bottom cover and lift the lid
Startingdateand Before mounting this kit, please read and understand these instructions and save the manual future reference
Follow the installation instructions step by step and in a very short time and be very easily assembled this scale wind turbine Your new
and original design make it easy be assembled without tools or glue
Samblás Once in place the model behind a window, so that the photovoltaic cell receives direct sunlight and small motor will spin the
blades
1 Open the bottom plate of the pedestal (A) and remove the blades (3 x D) and rotor cover (E)
ASSEMBLY
2 Pass the cord completely through the column, so that the connector protrudes through the wider end of it
Insert the bottom pivot of the nacelle (engine housing) at the narrow end of the column

3 Insert the widest part of the column (B) in
the pedestal (A)
The two tabs on the end of the column
should fit into the two slots in the pedestal
4 Plug the motor cable into the socket inside
the pedestal
Pay attention to small plug slots, because
only fits into the correct position
5 Insert the three blades (D) in the grooves of the rotor,
entering it from the front Monitor the correct position of
each blade
6 Place cover (E) of the rotor Insert it to the bottom
NOTE: This kit is recommended for children aged 8 years, always accompanied by an adult