Celsius CELOH15T User manual

OPERATING INSTRUCTIONS
OIL COLUMN HEATER WITH TIMER
For Model: CELOH15T

1. Use only the voltage specified on the rating
label of the appliance.
2. Keep all objects at least 1 metre from the
front, sides and rear of the appliance. Do not
place appliance close to radiant heat source.
3. Do not operate in areas where petrol, paint or
other flammable liquids are used or stored.
4. Do not insert or allow foreign objects to enter
any ventilation or exhaust opening, as this
may cause an electric shock, fire or damage
to the appliance. Do not sit on the appliance.
5. Do not operate this appliance with a
damaged cord, plug or after the appliance
malfunctions or has been dropped or
damaged in any manner. Return to a qualified
electrical person for examination, electrical
service or repair.
6. This appliance is intended for household use
only and not for commercial or industrial use.
7. Use this appliance only as described in this
manual. Any other use is not recommended
by the manufacturer and may cause fire,
electrical shock or injury.
8. The common cause of overheating is
deposits of dust or fluff in the appliance.
Ensure these deposits are removed regularly
by unplugging the appliance and vacuum
cleaning the air vents and grills.
9. Do not use abrasive cleaning products on this
appliance. Clean with a damp cloth (not wet)
rinsed in hot soapy water only. Always
remove plug from the mains supply before
cleaning.
10. Do not connect the appliance to mains supply
until completely assembled and adjusted.
11. Switch off and use handles provided when
moving.
12. Do not operate with cord set coiled up as a
heat build up is likely, which could be
sufficient to become a hazard.
13. Do not use an extension cord, powerboard, or
external Timer with this unit.
14. Do not remove plug from power socket until
the appliance has been switched off.
15. Do not remove plug from power socket by
pulling cord; always grip plug.
16. Always unplug appliance when not in use.
17. Do not locate the heater directly below any
power socket during operation.
18. Do not twist, kink or wrap the cord around the
appliance, as this may cause the insulation to
weaken and split. Always ensure that all cord
has been removed from any cord storage
area and is unrolled before use.
19. This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities or
lack of experience and knowledge, unless
they are supervised or have been given
instruction concerning the use of the
appliance by a person responsible for their
safety.
20. Do not use this appliance in the immediate
surrounds of a bath, a shower, or a swimming
pool or other liquids. The appliance must not
be immersed in any liquids.
21. When the appliance has been unpacked,
check it for transport damage and ensure all
parts have been delivered. If parts are
missing or the appliance has been damaged,
contact the Celsius Customer Services Team.
22. If your appliance does not work, or is not
working properly, contact the place of
purchase or the Celsius Customer Services
Team. Repair work on the appliance by
unqualified persons can cause serious risk to
the user.
23. There are no user serviceable parts installed
in the unit.
24. Do not place the unit in wardrobes or other
enclosed spaces as this may cause fire
hazards.
25. This unit is not supposed to be used in or
around locations where foodstuffs, works of
art or delicate articles of science, etc are
stored.
26. Indoor use only.
27. Children should be supervised to ensure that
they do not play with the appliance.
28. Ensure heater is on a flat, stable, heat-
resistant surface.
29. It is important that you do not cover this
heater.
WARNINGS AND SAFEGUARDS
Celsius –New Zealand
Monday –Friday 8am-5pm
Phone [phone]
Phone [phone]
[email protected]
Celsius –Australia
Monday –Friday 8am-5pm
Phone [phone]
Phone [phone]
[email protected]
SUPPORT AND TECHNICAL ADVICE

A. Main body
B. Handle
C. Adjustable thermostat
D. Heat control switch
E. Timer
F. Cable plate
G. Wheel assembly
H. Wheel
COMPONENTS
A
B
C
D
E
F
G
H
Main Body x1
Wing Nut x1
U-shape Bolt x1 Screw x2
Wheel Castor x2

ASSEMBLY OF THE HEATER
Carefully turn the heater upside-down on a non-scratching and stable surface to prevent damage to
the paint finish or your floor surfacing (Figure 1).
Fit the wheel castors onto the heater by placing the U-shaped bolt between the outermost fin away
from the control side of the heater (Figure 2, 3).
Securely fasten the wheel castors to the heater by screwing the wing nuts onto the U-bolts (Figure 4).
Attach the second wheel castor at the bottom of the control panel, then securely fasten the wheel
castor onto the heater with the two screws (Figure 5).
IMPORTANT: Please fit the wheel assemblies as per the diagram. Any other position may affect the
stability of the heater.
WARNING: Only operate the heater in normal upright position with wheel assemblies attached to the
bottom, any other position could create a hazardous situation.
ASSEMBLY

OPERATING YOUR OIL COLUMN HEATER
Always choose a safe location for the heater, keeping in mind the safety precautions outlined. Ensure
all packaging has been removed from the unit before use. This appliance requires no installation, it
should be used solely as a portable appliance.
PLEASE NOTE: As this product is fitted with a Timer, the Timer has been set to the “ON”
position. Please refer to the Timer section for setting instructions.
HEAT CONTROL SWITCH
The control switch positions are:
●Minimum heating
●● Medium heating
●●● Maximum heating
Check that the power On/Off switch is set to Off position before plugging the heater into the mains
supply. For greater economy, use the High Heat setting initially and then switch to the Low Heat
setting.
THERMOSTAT
Turn the thermostat knob clockwise until you reach the maximum temperature on the graduated
scale. When the desired room temperature is reached, slowly turn the knob anti-clockwise until the
heater turns off (you will hear a click). The heater will now cycle on and off to maintain the set
temperature.
IMPORTANT! NEVER COVER THIS HEATER
SAFETY DEVICES
This appliance has three protection devices:
The first device will automatically turn the appliance off if the appliance is not in the appropriate
operating position.
The second device automatically disconnects & reconnects the appliance at a pre-set temperature.
The third device disconnects the appliance permanently in case of overheating, by means of a
thermal fuse (it is non resettable).
WARNING: Keep all objects at least 1 metre from the front, sides and rear of the appliance.
WARNING: Do not use this heater with a programmer, separate Timer, remote-control system or any
other device that switches the heater on automatically.
CAUTION: The heater generates heat during use. Proper precautions must be taken to prevent the
risk of burns, scalds, fires or other damage to persons.

TIMER
You must set the time prior to programming the Timer. To do this turn; the outer dial of the Timer in a
clockwise direction until the time of the day (24-hour clock) corresponds with the triangular marking.
Example if it is 2pm (1400 hours) then set the triangular mark in line with 14. One complete turn of the
dial corresponds to 24 hours.
There are 96 “riders”, positioned around the dial, each rider represents 15 minutes.
Where all the “riders” are pushed to the outside of the Timer the heater will be ON continuously.
To set a specific time for example:
If you want the heater to be on from 6pm to 10pm, then set all the riders from 18 to 22 (1800 hours to
2200 hours) to the outside of the rim and all other riders to the inside of the Timer. The unit will then
turn on automatically at 6pm and off again at 10pm.
WARNING: Take care in positioning your heater. Using the Timer will mean the heater will come on
automatically. Fire may result if the heater has been placed next to combustible material.
Indicates actual time
Riders pushed to
the outside rim to
turn ON
CARE AND CLEANING
The heater requires regular cleaning to ensure trouble free operation:
Unplug the heater from the mains supply before cleaning.
Ensure that the heater has been allowed to cool down completely before cleaning.
Use a damp cloth (not wet) to wipe the exterior of the heater to remove dust and dirt.
Never use solutions such as benzene, thinners or polishing agents.
Use a vacuum cleaner to remove dust and fluff from around the grills and fins.
Ensure the heater is dry before plugging back into the mains supply.
Do not attempt to dismantle the heater. There are no user serviceable parts. For service or repair,
contact an authorised electrical service technician.
PROOF OF PURCHASE
To receive warranty retain receipt as proof of purchase.
TECHNICAL SPECIFICATION
Model No: CELOH15TM
Supply: 220-240VAC 50Hz
Wattage: 1500W

Thank you for purchasing this Celsius product. Your product is warranted against faults and manufacture when used in
normal domestic use for a period of one year. In non-domestic use Celsius limits the voluntary warranty to three
months.
Celsius undertake to repair or replace this product at no charge if found to be defective due to a manufacturing fault
during the warranty period.
This warranty excludes damage caused by misuse, neglect, shipping accident, incorrect installation, or work carried out
by anyone other than a qualified electrical service technician.
PLEASE KEEP YOUR RECEIPT AS THIS WILL HELP VERIFY YOUR WARRANTY.
The benefits given to you by this warranty are in addition to other rights and remedies available to you under law in
relation to the goods or services to which this warranty relates.
In Australia, our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are
entitled to a replacement or refund for a major failure and compensation for any other reasonably foreseeable loss or
damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the
failure does not amount to a major failure.
In New Zealand this warranty is additional to the conditions and guarantees of the Consumers Guarantee Act (1993).
One Year Warranty
Celsius One Year Warranty (IMPORTANT: Please complete and retain this warranty card)
Name
Address
Place Of Purchase Date Of Purchase
Name Of Product Model Number
Attach a copy of the purchase receipt to this warranty card
Due to continual design improvements, the product illustrated in this User Manual may differ slightly from the actual product.
Celsius –New Zealand
PO Box 100-707
N.S.M.C
Auckland
Phone [phone]
Phone [phone]
[email protected]
Celsius –Australia
PO Box 574
South Morang
Victoria, 3752
Phone [phone]
Phone [phone]
[email protected]