Champion Power Equipment 100306 Service manual

11/29/18 1 Champion Power Equipment, Inc.
Technical Bulletin
Number: 181128-60-20-1
Date: 11-28-18
Fuel Tank Light Indicator Battery Replacement
This covers the following models (Read completely before performing service):
•100306
•100402
•100414
•100565
•All other 2000W Clamshell Models
Follow the instructions below to replace the battery cell for the Fuel Tank Light Indicator for 2000W Clamshell
Inverters,
1. Use a small screwdriver to
disassemble the upper cover. Note:
There is a notch on both sides to
allow access with a screwdriver.
2. Move the round copper cover plate
and remove the battery cells.

11/29/18 2 Champion Power Equipment, Inc.
3. Keep the small spring attached to
the copper pillar and place the
compressed spring back into the
bottom of the assembly. Note: The
compressed spring will have the
small end facing outward
4. Place new battery cells back into
the assembly with negative (-) pole
facing upwards and positive (+)
facing towards the compressed
spring. Move the round copper
cover plate to cover and touch the
button cell.
5. Insert the small spring back into the
pocket of the upper cover and press
the upper cover into place to
complete the installation.
If you have any questions regarding the previous procedure, please contact our technical department
Monday-Friday from 8:30 AM-5:00 PM PST at 877-338-0999.
If you have any questions, please contact Champion Power Equipment:
Champion Power Equipment, Inc.
12039 Smith Ave.
Santa Fe Springs, CA 90670
Phone: [phone]
Email: [email protected]