Channel Vision 5125 User manual

CHANNEL VISION
Limited Warranty
Channel Vision Technology will repair or replace any defect in
material or workmanship which occurs during normal use of this
product with new or rebuilt parts, free of charge in the USA, for two
years from the date of original purchase. This is a no hassle warranty
with no mail in warranty card needed. This warranty does not cover
damages in shipment, failures caused by other products not supplied by
Channel Vision Technology, or failures due to accident, misuse, abuse,
or alteration of the equipment. This warranty is extended only to the
original purchaser, and a purchase receipt, invoice, or other proof of
original purchase date will be required before warranty repairs are
provided.
Mail in service can be obtained during the warranty period by calling
[phone] toll free. A Return Authorization number must be
obtained in advance and can be marked on the outside of the shipping
carton.
This warranty gives you specific legal rights and you may have other
rights (which vary from state to state). If a problem with this product
develops during or after the warranty period, please contact Channel
Vision Technology, your dealer or any factory-authorized service
center.
500-10
3
Black & White
IR illuminated Camera
234 FISCHER AVENUE •C
[phone] • [phone] • [phone] fax
www.channelvision.com • email: [email protected]
©2005,CHANNEL VISION™
OSTA MESA, CA 92626
Model 5125

2
Model 5
12
5
Coax extension
(not included)
Power supply
(included)
To Monitor
or
Video distribution
Power
2-Conductor power
supply extension
(not included)
Crimp-on splice
connectors
(not included)
Side view Front view
Video
(BNC connector)
Installation:
h
h
h
h
Attach the camera mount to a wall or ceiling using the 3
screws provided.
Drill a hole in the wall or ceiling for wiring (see diagram).
If necessary, attach the camera’s video output to a coax
extension that is long enough to reach your monitor or
video distribution equipment.
If necessary, cut the connector off of the end of the power
supply and splice in an extension using crimp-on
connectors.
3
Specifications:
Camera Lens:
Resolution:
S/N Ratio:
Min Illumination:
Power Supply:
Power Consumption:
Video Output:
Scanning System:
Waterproof criterion:
Dimensions:
Operating Temp:
3.6mm
420 lines
More than 48 dB
0.5 LUX @ F2.0 (Before IR is activated)
12VDC regulated
210 mA
1 Vp-p @ 75 ohms
interlaced 2:1
IP 67
2.1”Dia. x 2.3”L (body only)
-10°C to 50°C (14°F to 122°F)
Specifications subject to change without notice.
Features:
1/3” Sony CCD
420 Lines Of Resolution
0 Lux Sensitivity
3.6mm Lens
Power Supply Included
U-shaped mount Included
Weatherproof
Sun Shield Included