Introduction
Congratulations on the purchase of your new CHAUVET lighting
stand. We are confident you will enjoy many trouble free hours with
thisunit. To assist with the care and use of the product we have pre-
pared this short guide.
Operation
This tripod stand has been designed to hold a maximum of 100lbs.
balanced evenly on the lighting bars.
Loosen leg extension knob and pull outwards on legs to widest posi-
tion for optimum stability. Tighten leg extension knob. Tighten set
screw with supplied allen wrench.
Loosen lower pole extension knob and pull pole upwards to fully
extend lower pole. Tighten pole extension knob. Tighten set screw
with supplied allen wrench.
Loosen lower lighting bar knobs. Slide the lighting bars onto upper
pole extension and tighten. Be sure that the support bracket is fully
extended.
Top Lighting Bar
Mounting Screws
Lighting Bar Knob
Lower Lighting Bars
Upper Pole
Extension Knob
Lower Pole
Extension Knob
Leg Extension
Knob
Loosen top lighting bar knob. Snap lighting bar into upper pole
extension.
Using supplied mounting screws, secure lighting effects to lighting
bar. Take care to balance weight evenly. Do not exceed 100 lbs.
Loosen upper pole extension knob and raise pole to desired height.
Stand extends a maximum of 9ft.
Installation/Mounting
This unit has been designed to be set on a flat level surface.
Failure to do so could cause serious injury.
Cleaning
The body of the unit should be cleaned with a soft damp cloth.
Other Products from Chauvet
PAR38C
Chrome
Also A vailable in
black
F750
Category I
Fogger
CH-219
Obsession
CH-323
Zipper
