Chauvet CH-W28 User manual

CHAUVET, 3000 N 29th Ct, Hollywood, FL 33020 U.S.A
[phone] – [phone]
FAX [phone]
www.chauvetlighting.com
CH-W28
Tripod Stand with Casters
USER MANUAL

CHAUVET, 3000 N 29th Ct, Hollywood, FL 33020 U.S.A
[phone] – [phone]
FAX [phone]
www.chauvetlighting.com
BEFORE YOU BEGIN
What is included
¾1 x CH-W28 Tripod Stand
¾Mounting plate
¾3 x rubber caps
¾3 x locking casters
¾Manual
¾Warranty Card
Unpacking Instructions
Immediately upon receiving a product, carefully unpack the carton, check the contents to ensure that
all parts are present, and have been received in good condition. Notify the shipper immediately and
retain packing material for inspection if any parts appear damaged from shipping or the carton itself
shows signs of mishandling. Save the carton and all packing materials. In the event that a product
must be returned to the factory, it is important that the product be returned in the original factory box
and packing
Caution
•This tripod is intended for use in flat surfaces.
•Maximum Load should not exceed 65lbs.
•Maximum height should not extend 6 feet.
•Always use the safety pins provided.
•Spread tripod legs so as to prevent tip over from sudden movements.
•Take care to not over tighten knobs.

Appendix
ASSEMBLY
Locking casters
Locking casters come loose and
will need to be assembled if
desired. The casters have a
threaded bolt that will screw into
the bottom of the tripod leg.
Mounting plate
The mounting plate fits most
speaker cups. It is also compatible
with the TFX-FS360 followspot.
Rubber caps (not shown)
Rubber caps are provided and
can be used to cover the bottom
of the tripod legs if you decide not
to use the locking casters.
Safety pin
Please use the safety pin to
prevent top loads from slipping.
Tripod can extend 6 feet.