Pearl Lauren User manual

Lauren
Audrey
Voltage / Tension: ~120V
Frequency / Fréquence: 60 Hz
Wattage / Puissance en watts: 27 W
Lamp /Lampe: 12v DC LED Light Strip
Audrey
Lauren
Zone
2
Zone
2
Zone
2
Zone
1
Zone
2
Zone
3
60cm radius
225cm 75cm
60cm 60cm
All fittings must be installed by a competent
person, in accordance with current IEE wiring
regulations. If in doubt, consult a qualified
electrician.
Switch off the electrical supply at the mains
BEFORE installation and maintenance. Suitable
for Bathroom Zones 2, 3 and non bathroom/ dry
areas. See diagram below.
DO NOT connect to a plug and socket outlet.
NOT suituble for above baths (Zone 1) nor for
installation saunas, steam rooms or shower
cubicles.
Rated IP44 and suitible for indoor use only.
Do not fix to damp or conductive surfaces.
Never cover the mirror.
Site well away from curtains and fabrics.
LifeWithPearl.com
User Manual
Voltage / Tension: ~ 120V
Frequency / Fréquence: 60 Hz
Wattage / Puissance en watts: 24 W
Lamp / Lampe: 12v DC LED Light Strip
Size / Taille: 24" X 32"
Size / Taille: 30" X 36"
WARNING:
MIRROR SPECIFICATIONS
Mirrors

Switch off the electrical supply at the mains before beginning.
Carefully read through the warnings and precautions on the rear on this
instruction manual.
Inspect the product immediately upon receipt for transit damage, missing
parts or manufacturing faults.
Handle the product with care and protect against knocks to all sides and
edges of the glass.
Fixings supplied are for use in solid walls, hollow or stud walls will require
specialist fixings available from your hardware supplier.
Make sure that you have all the tools you need to complete the job
(See below).
Ensure there are no hidden pipes or cables in the wall before drilling.
If drilling holes in ceramic tiles use a piece of masking tape on the tile to
stop the drill bit from slipping.
y
y
H
1
4
7
56
B
A
23
B
A
Ø 6mm
2-3mm
wall tiles
Before You Begin
Introduction
Tools Required
How to Use
Maintenance
To turn the LED light off and on simply tap on the square
located on the lower front of the mirror.
The LED lights can be adjusted between three colour
temperatures, 3000k, 4000k and 6000k. To toggle
between them, press and hold the on/off button.
Electric Drill Safety Glasses
Thank you for purchasing an authentic Pearl® LED mirror. Crafted from
high quality materials each component is carefully inspected before
leaving the factory.
Please read the instructions carefully to prevent malfuntion or damages.
Philips Screwdriver
Level Tape Measure
Pencil
Measure the distance between the
two ends, this mirror can be hung
horizontal or vertical.
Leave a 2-3mm gap between the
screwhead and wall.
Slide the mirror down onto the
screws, check if secure.
A: Connect the wires properly to
their corresponding colour.
B: Lift the mirror above the screws.
A: Insert wall plugs
B: Insert screws
Using a pencil and a level, mark the
desired position on the wall.
Drill the holes for wall plugs.
Clean using a soft dry cloth only when turned off. Never
use cleaning agents or abrasive materials. Do not allow
moisture to come into contact with the lamps.