CP7263, CP7264, CP7266, CP7267 Series
Discover other air sanders and polishers on our website.
Technical Data
Pad size:
CP7263 Series: 3”x4-1/4” (75x110mm)
CP7264 Series: 2-3/4”x7-3/4” (70x198mm)
CP7266 Series: 3-1/4”x5” (80x130mm)
CP7267 Series: 3-7/8”-5-5/8” (100x144mm) delta shape
Free speed; 10 000 RPM
Air pressure 90 psi (6.3 bar)
Air comsumption; 18 cfm - 8,5 l/s
re. ISO 28927-3.
Declaration of noise and vibration emission
All values are current as of the date of this publication.
These declared values were obtained by laboratory type testing in
accordance with the stated standards and are suitable for comparison
with the declared values of other tools tested in accordance with the
same standards. These declared values are not adequate for use in risk
assessments and values measured in individual work places may be
higher. The actual exposure values and risk of harm experienced by an
individual user are unique and depend upon the way the user works,
the workpiece and the workstation design, as well upon the exposure
time and the physical condition of the user.
We, Chicago Pneumatic, cannot be held liable for the consequences of
using the declared values, instead of values reflecting the actual
exposure, in an individual risk assessment in a work place situation over
which we have no control.
This tool may cause hand-arm vibration syndrome if its use is not
adequately managed.
We recommend a programme of health surveillance to detect early
symptoms which may relate to noise or vibration exposure, so that
management procedures can be modified to help prevent future
impairment.
INSTRUCTION MANUAL
Lubrication
Maintenance
Tune-Up Kit:
Random orbital sander
Noise & Vibration Declaration*
ccordance with EN ISO 15744. For sound power, add 11
dB(A).
Vibration value,
Machine Type:
Pneumatic tool equipped with a flexible disc
fitted with abrasive paper for sanding - No other
use is permitted.
Air Supply Requirements
1.Supply tool with 90 psig (6.3 bar) of clean, dry air. Higher
pressure drastically reduces tool life.
2.Connect tool to air line using pipe, hose and fitting sizes
shown in the diagram below.
3.Do not install a quick coupler directly into the sander
throttle handle.
