CHIEF PAC-400 User manual

INSTALLATION INSTRUCTIONS
PAC-400
LARGE FLAT SCREEN ROTATION ACCESSORY
Prior to assembly, unpack carton completely and verify contents.
If you are missing any of the following components, please contact Customer Service at 1-800/582-6480
(1) Rotation Assembly (4) Mounting Buttons-Tapped 10-24
(4) 10-24 x 1/4” Phillip Head Cap Screw (4) 10-24 x 3/8” Flat Head Security Screws
(1) 5/32” Security Hex Key (2) Latching Flags
BEFORE PROCEEDING, READ INSTALLATION INSTRUCTIONS COMPLETELY
LARGE FLAT SCREEN DISPLAYS ARE EXTREMELY
FRAGILE.
1. Remove screen from Chief Mount or, if not installed, install PSB interface bracket to back of screen
per instructions supplied with mount.
2. Attach mounting buttons to Rotation Assembly, making sure the buttons are securely fastened.
(see Figure 2 & Figure 3).
CAUTION!
Figure 1
Figure 2 Figure 3

01/26/04 8809-000007
CHIEF MANUFACTURING INC. 1-800-582-6480, Fax: [phone], Email: [email protected]
3. Attach PAC-400 to PSB Interface Bracket by placing the mounting buttons of PSB into the
teardrop slots of PAC-400. Make sure the mounting buttons are placed securely in teardrop
slots. (See Figure 4).
4. Place Latching Flags over buttons and secure using 10-24 phillips head cap screws. Use 10-24
undercut security screws and security hex key instead of phillips screws for added security.
(See Figures 5 & 6).
5. Set desired amount of friction for rotating screen by tightening or loosening nuts (4) on back side of
PAC-400. (See Figure 7).
6. With the aid of another person, lift Large Flat Panel Display and PAC-400 up to Chief Mount,
aligning buttons of rotation accessory with slots in the Chief Mount.
7. Raise safety latch on Chief Mount to secure Display, making sure latch is completely engaged.
8. If you wish to rotate screen the other way, take screen and rotation accessory from Chief Mount,
rotate the back plate of the PAC-400 by 90 degrees.
9. Install screen on Chief Mount.
10. Use holes on outside bends to tie wires for cable management. (See Figure 7).
11. On tilting mounts, you may have to increase friction on tilting mechanism since PAC-400 adds depth
to overall installation and roll adjustment on PDS mount may need tightening.
Figure 4
Figure 5
Figure 7
Figure 6