CHIEF FSB-4225 Service manual

INSTALLATION INSTRUCTIONS
CHIEF MANUFACTURING INC. 8804-000206 REV. A
1-800-582-6480 952-894-6280 FAX [phone] Chief Manufacturing
8401 EAGLE CREEK PKWY, STE. 700 www.chiefmfg.com
SAVAGE, MINNESOTA 55378 USA 10/04
DISPLAY STATIC MOUNT
FSB-4225
(1) FSB Interface Bracket (4) Tapped Mounting Buttons
(4) M4 x 6mm Phillips Pan Head Screws (4) 10-24 x .5 Button Head Cap Screw
(4) .50” Diameter Rubber Bumper (4) 1/8” Hex Key
BEFORE PROCEEDING: Unpack the carton, verify contents shown in Figure 1 and read
installation instructions completely. If you are missing any of the listed components, please
contact Customer Service at 1-800/582-6480.
Displays are Extremely Fragile.
1. Attach the four (4).50” Diameter Rubber Bumpers to the four (4) “X” location markings
located on the Interface Bracket (see Figure. 2).
2. Interface installation
**If used with any small flat screen system using Chief Manufacturing’s Q2 (5” x 5”) mounting system.
2a. Using 1/8” Hex Key, assemble (4) mounting buttons to 5” hole pattern on the adapter bracket with the
four (4) 10-24 x .50” Button head cap screws (see Figure 3).
CAUTION!
Figure 1
Figure 2 Figure 3

**Optional VESA Mounting
2b. Attach Interface bracket to Display Screen (see Figure 4).
2c. Using four inside tapped holes of interface bracket and M4 x 6mm Phillips Screws (provided), secure
adapter bracket to any mounting device using a 100mm x 100mm VESA pattern.
Figure 4