Minimum Sheetrock Thickness ½ Inch.
Drywall Installation Procedures:
1. Using the wall bracket as a template at the desired mounting location, mark the location of the four
outer mounting holes.
2. Using a 3/8-inch drill, drill four pilot holes
to a minimum depth of 1 1/2”
at the locations marked in
Step 1.
3. Install an anchor bolt in one of the pilot holes and tighten anchor bolt until it is fully seated (see
Figure 3).
4. Remove and retain bolt from anchor and repeat Step 3 and 4 for three remaining anchor bolts.
5. Install .25 ID X .56 OD flat washer on each of four bolts removed from anchors.
6. Using four bolts, with washers installed, secure wall bracket to wall.
Wood Stud Installation Procedures:
1. Locate stud and, using wall bracket as a template at the desired height, mark the location of the two
center mounting holes.
2. Install a flat washer on each of the two wood screws.
3. Using the two wood screws with flat washers installed, secure wall bracket to wall.
Mounting Display with Interface Bracket to Wall Bracket:
1. Make sure the latching flag on the mounting bracket is in the unlocked position (see Figure 4).
2. Place your small flat panel display; with interface bracket attached, onto the wall bracket, making
sure it is securely seated.
3. Lower the latching flag on the wall bracket, locking small flat panel display in place (see Figure 5).
Figure 4 Figure 5
Locke
CAUTION!
Outer Mountin
Holes
Figure 3
%%c0.375
PREDRILL HOLE
INSERTANCHO R INTOPPREDRILLED HOLE
CW
NCHOR BARBP
STOPSANCHORROTATION
#10-24 Screw O 0.375 (Predrill Hole)
Insert anchor into
predrilled hole Anchor Barb
(Stops anchor rotation)
Ancho
Turn 10-24 screw clockwise
until anchor fully seats
against back side of wall
CW
Unlocke
Center Mounting Holes
