6. Adjust lighting time by rotating adjusting knob(Fig.3). Mark "*" means longer lighting time.
7. Adjust ambient luminance when it can be activated(Fig.3). Mark oo * " means it is brighter when light activated.
8. Adjust angle of PIR head you wanted(Fig.3).
9. After installation finished the light will operate automatically. Charge for at least 8 hrs in full sun exposure (the
fixtures switch MUST be in the ON position in order for the battery to charge).
At night it can be activated by motion und turn off at dawn Qight will only come on at night).
t.
The Ni-MH battery included with this product is rechargeable. Like all rechargeable batteries, however, they will
eventually need to be replaced. If the light should begin to illuminate dimly or work improperly, you should replace
the rechargeable batteries in the following way
Take a screw driver and unscrew the six screws at the back ofsolar panel and take offthe back cover gently and
softly to avoid damaging the wires.
Pull out the wire connector connected to circuit board.
Take off the old battery pack..
Replace new battery pack of same kind and capacity.
IMPORTA|IT! When storing any solar product for an extended period of time, be sure to remove the batteries.
Storing any solar product without regular recharge or removal could cause permanent damage to the rechargeable
batteries.
Fig.3
2.
4.
Lishtine sensitivity
adjusting knob
Duration time
adjusting knob
DO NOT DISPOSE OF OLD BATTERIES _ THEY SHOT]LD BE RECYCLED.
