Chord Electronics
BLU MKII | Manual
_
Protection against
liquids & heat
1.2
BLU MKII is not
protected against liquids
of any kind. Never place
containers of liquid on BLU MKII.
Never allow BLU MKII to come
into contact with moisture or
liquids; doing so could result in
electrocution or damage to the
BLU MKII’s internal circuitry.
Be aware that liquids, including
water that has dried, can leave
minerals that can aect the
PCB and other components,
which could eventually lead to
oxidisation and short-circuiting.
If the BLU MKII comes into
contact with moisture or liquids,
immediately disconnect from
the mains power supply, and
connected equipment and
contact Chord Electronics for
further advice.
The BLU MKII has
internal thermal
protection which will
shut down the unit in the event
of excessive temperatures being
reached. Never operate the BLU
MKII near sources of heat or
naked flames as this will decrease
the lifespan of the internal
components. It is advised that
you do not operate the BLU MKII
in an area of direct sunlight or on
top of significant heat- producing
devices.
Please be aware that it is
entirely normal for the BLU
MKII to become warm during
use, particularly within a
stacked configuration. If you
are concerned about the
temperatures, please switch the
device o or consider a dierent
placement.
1.1 Introduction
1.2 Protection against
liquids & heat
1.3 Dismantling & radio frequency
interference
1.4 Connecting your equipment
5 // 28
