chromagen MIDEA 170L Instruction Manual

170L Heat
Pump: Quick
Start Guide
1
Position unit on a flat sturdy surface able
to bear the weight of a fully filled unit.
QUICK
START
INSTALLATION
GUIDE
MIDEA
HEAT PUMP
170 LITRE
Fit the condensation tube to the lower port on the rear of
the unit and run to suitable location.
Remove top cover (to access the electrical compartment)
by removing the locking screw and rotating in a clockwise
direction. Simply lift up to remove and put aside.
Connect the hot pipe, the cold pipe (ensure non-return valve is
used at the tank location) & connect PTR valve (drain to legal
point of discharge)
HEAT PUMP PTR VALVE
INSTRUCTIONS
BOX CONTENTS
CONDENSATION TUBE
UV SCREEN COVER
FASCIA COVER

Pumped
Systems:
200/300L OL
2
170L Heat
Pump: Quick
Start Guide
2
Fill heater with water and bleed air through unit by
opening a hot water tap inside the house
Turn heater on by pressing the on/off button twice
(Ensure the red LED is lit up). Heater should start running.
For best energy efficiency Chromagen recommends the
unit is set to 'economy mode'
Wire electrics by feeding the cable through the access hole on the under face of the upper section of the unit and up to
the electrical compartment. Remove electrical compartment cover by releasing the two screws & wire accordingly.
(Where possible terminating the electrical connection with a suitable isolating switch (By authorised electrician)
Reposition the units top cover and rotate in an counter-
clockwise direction to lock. Secure with previously
removed screw.
Fit the fascia cover using the locating pins at the top &
magnet at the lower position (for successful fit ensure
protective tape on the magnet is removed)
Switch Power OnFit UV Screen cover to the control
panel using a strip of d/sided tape
across top edge