ChronoRemoteControl TR2 User manual

www.ChronoRemoteControl.com
Manual
APRIMATIC TR2, TR4, TR2M and TR4M
To operate your new remote, you must code it:
A. Coding based on a remote control already in operation.
Position yourself near the radio receiver.
1) Simultaneously press all the buttons on the remote already in use until the
receiver emits a continuous beep.
2) Simultaneously press all the buttons on the new remote control. The acoustic
signal stops 1.5 sec, confirming the registration of the new remote control.
3) Release all buttons.
4) Press any key on the new remote. The buzzer should stop 1.5 sec and then
resume. The end of the beep (after about 30 seconds) signals the end of the
registration period.
5) Test your new remote control.
Note: If the buttons are not all pressed at the same time, the receiver does not
recognize the new remote.

www.ChronoRemoteControl.com
B. Coding based on a radio receiver.
1) Open the radio receiver of your installation. (Locate it by following the
antenna wire).
2) Press the push button on the radio card for 2 seconds. A light appears on the
radio card. The receiver is now in learning mode.
3) Press the button 1 on your new remote control for 1 second (the button next
to the letter A fromAPRIMATIC). Do the same with all your new remotes.
4) After about 15 seconds, the radio card indicator light turns off, signaling the
transition from receiver to normal reception.
5) Test your new remotes.
6) Close the radio receiver.