Cianna Medical SCOUT Check User manual

SCOUT®Check

2
Overview
SCOUT Check SAVI SCOUT System
Console housing Same Same
Console front face Gray Black
Sound Constant cadence –no
change with proximity Increasing cadence with proximity
Visual LED Lights for
modes/messages Display with numbers, modes/messages
Volume control None Up/down
Handpiece Reusable, gray cable Single use, white cable

3
System Setup: Components
Console
Handpiece
Reusable

4
Console Overview
Start/Stop
Button
Handpiece
receptacle
connector
SYSTEM READY
Indicator
DETECT MODE
Indicator
HOLD STEADY
Indicator

5
System Setup: Console
Place console on top of cart or other equipment
Position console to accommodate 5 ft. handpiece cable
(i.e. side of patient table vs. foot of table)
Attach power cord to console and plug into outlet
Power on/off
switch
Power cord
receptacle
Fuse Drawer

6
System Setup: Handpiece
Attach handpiece to console
Align arrow on handpiece connector with notch on console port
Press until secure connection made between handpiece and console
Handpiece
receptacle
connector
Alignment
arrow
Alignment
notch

7
System Setup: Power up
Turn on ‘Power’ switch on back of
console
START/STOP button on front of
console will activate
Wait for ‘SYSTEM READY’ indicator
light: green
Blinking ‘Ready’ light = error
Check handpiece connections
Turn console off, then on again
If blinking persists, attach new
handpiece
Power on/off
switch

8
Press ‘START/STOP’ button to activate
handpiece
‘DETECT MODE’ indicator: Green
Place handpiece on Handpiece Test Card as
indicated
Positive test –audible clicking
Negative test –no sound
Replace with new handpiece
System Setup: Handpiece Test
System is now ready for reflector verification

9
Post-Reflector Verification
System shut down
Press START/STOP button
Turn off power switch
Disconnect handpiece and store in safe place
Unplug power cord if console will be moved or stored
Cleaning
Console: wipe all console surfaces, including power cord with a
mild cleaning solution or disinfectant and a damp cloth
Handpiece (see Handpiece IFU for full cleaning instructions)
Wipe off obvious contaminants
Use moistened wipe (CaviWipe) to remove any remaining contaminants
or gross debris
For use as a disinfectant, use second CaviWipe to thoroughly wet
surface