Coyote CD108S User manual

MADE IN USA
CD108S
Small Integrator™
Socket Adapter
Weight limit 265 lbs
419 Curtis Rd, Boise, ID 83706
[phone]
www.coyotedesign.com
External Prosthetic Components
CD108S.rev.11132019
DEFINITIVE SOCKET FABRICATION
1. Place Small Integrator™ in desired location on mold and trace location
2. Pull PVA bag over mold. Using heat ensure edge of PVA bag is within the inner diameter of the Small Integrator™.
3. Carefulle glue Small Integrator™ to mold and PVA bag.
4. Place in alignment fixture and attach alignable connector at desired alignment. Remove from fixture.
5. Lay up as normal reinforcing between connector posts.
6. Tie Lay up into the tie in ring in the Small Integrator™.
7. Install Five Hole Plate using provided screws.
8. From here socket is laminated in preferred fashion.
9. Remove Five Hole Plate. Finish Socket as usual.
Quick Adhesive will NOT stick to Small Integrator™ permanently
For further fabrication and connector options see back page
Results can only be guaranteed if Coyote® Quick Adhesive is used
This piece of paper is NOT packing material. It is
instructions for the product also enclosed in the package.
These instructions could be helpful in fabricating and
using the product correctly. We recommend reading them
BEFORE using.
If you have more questions please call
Coyote at [phone].
You can also visit coyotedesign.com and check out
fabrication videos on:
• Attaching the Alignable Connector
• Fabricating the check socket
• Fabricating the definitive socket
1
2
4.
5.
PARTS IN THIS PACKAGE
Advena Limited
Tower Business Centre
2nd Flr, Tower Street
Swatar, BKR 4013
Malta

Check socket with Connector and insert
1. Place Small Integrator™ in desired location on mold and
trace location. Install o-ring
2. Drill 3/8” hole for nylon knot. Prep cast in customary fashion
3. Ensure nylon will fit fully under Small Integrator™ to keep
socket airtight.
4. Glue Small Integrator™ to mold in desired location
5. Install insert of choice (CD103MDI or CD103SDI) into
Alignable Connector (CD103AF)
6. Slide connector onto Small Integrator™ in desired location
with posts facing away from Small Integrator™
7. Place foam dots on posts
8. Fabricate over mold, Small Integrator™, and connector
We typically drape copoly, but other plastics and
methods can be used.
When plastic has cooled, expose foam dots, and grind the bottom
of the socket as flat as possible without damaging posts
Using the Alignable Connector a single lamination with built in
offset alignment can be done. For more information see
instructions with Alignable connector
CD103MDI CD103SDICD103AF