Cisco SPA112 User manual

Cisco SPA112 \ Cisco SPA122
1. Setup occurs in the web interface. To log into it, enter the gateway IP address in your
browser’s address bar. You can find the gateway IP address by connecting a phone to it
and dialing ****110#. The default username and password are both admin.
2. Open Voip>SIP and enter the following RTP port range:
RTP Port Min: 1024
RTP Port Max: 65455

3. Open Voip => Line1 and enter the following information:
NAT Mapping Enable: no
NAT Keep AliveEnable: yes
Proxy: login.smarttelplus.eu
Register Expires: 300
Display Name: your SIP number (111111, for example) from Settings => User
management
UserID: your SIP number (111111, for example) from Settings => User management
Password: your password for the SIP number from Settings => User management
Preferred Codec: G711a
Second Preferred Codec: G711u
G.729a Enable: yes
To make sure that incoming calls are transferred correctly in NPBX, list the following
parameters:
DTMF Tx Method: auto
DTMF Tx Mode: normal

To save your changes, click Submit.