Cisco PAP2T User manual

Data Sheet
© 2008 Cisco Systems, Inc. All rights reserved. This document is Cisco Public Information. Page 1 of 5
Cisco PAP2T Internet Phone Adapter with 2 VoIP Ports
Cisco Small Business Voice Gateways and ATAs
Feature-Rich VoIP Service Through Your High-Speed Internet Connection
Highlights
●Enables high-quality feature-rich voice over IP (VoIP) service through your broadband
Internet connection
●Dual standard telephone ports for use with analog phones or fax machines, with
independent phone numbers
●High-quality, clear-sounding voice, using advanced voice quality of service (QoS) capability
●Compatible with all common telephone features, such as caller ID, call waiting, and
voicemail
Figure 1. Cisco PAP2T Internet Phone Adapter with 2 VoIP Ports
Product Overview
The Cisco PAP2T Internet Phone Adapter with 2 VoIP Ports (Figure 1) enables high-quality
feature-rich VoIP service through your broadband Internet connection. Just plug it into your home
router or gateway and use the two standard telephone ports to connect analog phones or fax
machines. Each phone port operates independently, with separate phone service and phone
numbers, like having two telephone lines. You'll get clear reception and reliable fax connections,
even while using the Internet.

Data Sheet
© 2008 Cisco Systems, Inc. All rights reserved. This document is Cisco Public Information. Page 2 of 5
With Internet telephony, along with low domestic and international phone rates, impressive arrays
of special telephone features are available. Choose your preferred local dialing number,
regardless of where you live. Or add a virtual telephone number to have forwarded to your Internet
phone. You can even add a toll-free number. The Cisco PAP2T Internet Phone Adapter is
compatible with these and all of the other special telephone features that are available from your
Internet telephone service provider, such as caller ID, call waiting, voicemail, call forwarding,
distinctive ring, and much more.
Features
Telephony
●Two voice ports (RJ-11) for analog phones or fax machines
●Impedance agnostics - eight configurable settings
●Call waiting, cancel call waiting, call waiting caller ID
●Caller ID with name/number (multinational variants)
●Caller ID blocking
●Call forwarding: no answer, busy, all
●Do not disturb
●Call transfer
●Three-way conference calling with local mixing
●Message waiting indication - visual and tone based
●Call return
●Call back on busy
●Call blocking with toll restriction
●Delayed disconnect
●Distinctive ringing - calling and called number
●Off-hook warning tone
●Selective/anonymous call rejection
●Hot line and warm line calling
●Speed dialing of eight numbers/addresses
●Music on hold

Data Sheet
© 2008 Cisco Systems, Inc. All rights reserved. This document is Cisco Public Information. Page 3 of 5
Specifications
Table 1 contains the specifications and package contents for the Cisco PAP2T Internet Phone
Adapter with 2 VoIP Ports.
Table 1. Specifications for the Cisco PAP2T Internet Phone Adapter with 2 VoIP Ports
Specifications
*Note: Many specifications are programmable within a defined range or list of options. Please see the PAP2T
Administration Guide for details. The configuration profile is uploaded to the PAP2T at the time of provisioning.
Data networking ●MAC address (IEEE 802.3)
●IPv4 (RFC 791) upgradeable to v6 (RFC 1883)
◦
Address Resolution Protocol (ARP)
●DNS-A record (RFC 1706), SRV record (RFC 2782)
●Dynamic Host Configuration Protocol (DHCP) client (RFC 2131)
●Internet Control Message Protocol (ICMP) (RFC 792)
●TCP (RFC 793)
●User Datagram Protocol (UDP) (RFC 768)
●Real Time Protocol (RTP) (RFC 1889) (RFC 1890)
●Real Time Control Protocol (RTCP) (RFC 1889)
●Differentiated Services (DiffServ) (RFC 2475), type of service (ToS) (RFC 791/1349)
●Simple Network Time Protocol (SNTP) (RFC 2030)
Voice gateway ●Session Initiation Protocol (SIP) v2 (RFC 3261, 3262, 3263, 3264)
◦
SIP proxyredundancy- dynamic via DNS SRV, A records deregistration with primary
SIP proxy server
●SIP support in network address translation (NAT) networks (including Serial Tunnel
[STUN])
●Highly secure (encrypted) calling via prestandard implementation of Secure RTP
●Codec name assignment
Voice algorithms ●G.711 (A-law and µ-law)
●G.726 (16/24/32/40 kbps)
●G.729 A
●G.723.1 (6.3 kbps, 5.3 kbps)
●Dynamic payload
●Adjustable audio frames per packet
Fax capability ●Fax tone detection pass-through
●Fax pass-though - using G.711
●Dual-tone multifrequency (DTMF): in-band and out-of-band (RFC 2833) (SIP info)
●Flexible dial plan support with interdigit timers and IP dialing
●Call progress tone generation
●Jitter buffer - adaptive
●Frame loss concealment
●Full duplex audio
●Echo cancellation (G.165/G.168)
●Voice activity detection (VAD) with silence suppression
●Attenuation/gain adjustments
●Flash hook timer
●Message waiting indicator (MWI) tones
●Visual messaging waiting indicator (VMWI) via frequency shift keying (FSK)
●Polarity control
●Hook flash event signaling
●Caller ID generation (name and number) - Bellcore, DTMF, European
Telecommunications Standards Institute (ETSI)
●Music on hold client
●Streaming audio server - up to 10 sessions

Data Sheet
© 2008 Cisco Systems, Inc. All rights reserved. This document is Cisco Public Information. Page 4 of 5
Security ●Password-protected system reset to factory default
●Password-protected administrator and user access authority
●Provisioning/configuration/authentication:
●HTTPS with factory-installed client certificate
●HTTP digest - encrypted authentication via MD5 (RFC 1321)
●Up to 256-bit Advanced Encryption Standard (AES) encryption
Provisioning, administration,
and maintenance ●Web browser administration and configuration via integral web server
●Telephone keypad configuration with interactive voice prompts
●Automated provisioning and upgrade via HTTPS, HTTP, Trivial File Transfer Protocol
(TFTP)
●Asynchronous notification of upgrade availability via NOTIFY
●Nonintrusive, in-service upgrades
●Report generation and event logging
●Stats in BYE message
●Syslog and debug server records - per-line configurable web browser
Physical interfaces ●One 10BASE-T RJ-45 Ethernet port (IEEE 802.3)
●2 RJ-11 FXS phone ports - for analog circuit telephone device (tip/ring)
Subscriber line interface
circuit (SLIC) ●Ring voltage: 40–55 volts root mean square (Vrms) configurable *
●Ring frequency: 10–40 Hz *
●Ring waveform: trapezoidal and sinusoidal *
●Maximum ringer load: 3 ringer equivalence numbers (RENs)
●On-hook/off-hook characteristics:
◦
On-hook voltage (tip/ring): -50V nominal
◦
Off-hook current: 25 mA min
◦
Terminating impedance: 8 configurable settings, including North America 600 ohms,
European CTR21
Regulatory compliance FCC (Part 15, Class B), cUL, CE, IC-003, A-Tick
Power supply ●DC input voltage: +5V DC at 2.0A max.
●Power consumption: 5W
●Switching type (100–240V) automatic
●Power adapter: 100–240V - 50–60 Hz (26–34 VA) AC input, 1.8 m cord
Indicator lights/LED Phone1, Phone2, Internet, Power
Documentation ●Quick-start installation and configuration guide
●User guide
●Administration guide - service providers only
●Provisioning guide - service providers only
Environmental
Dimensions
W x H x D 3.98 x 3.98 x 1.10 in. (101 x 101 x 28 mm)
Unit weight 5.40 oz (153 g)
Operating temp. 32º to 113ºF (0º to 45ºC)
Storage temp. -77º to 158ºF (-25º to 70ºC)
Operating humidity 10% to 90% noncondensing
Storage humidity 10% to 90% noncondensing
Package Contents
●Cisco PAP2T Internet Phone Adapter with 2 VoIP Ports
●Power adapter
●RJ-45 Ethernet cable
●Quick installation guide
Product Warranty
1-year limited hardware warranty with return to factory replacement and 90-day limited software warranty

Data Sheet
© 2008 Cisco Systems, Inc. All rights reserved. This document is Cisco Public Information. Page 5 of 5
Cisco Limited Warranty for Cisco Small Business Series Products
This Cisco Small Business product comes with a 1-year limited hardware warranty with return to
factory replacement and a 90-day limited software warranty. In addition, Cisco offers software
application updates for bug fixes and telephone technical support at no charge for the first 12
months following the date of purchase. To download software updates, go to:
http://www.cisco.com/go/smallbiz.
Product warranty terms and other information applicable to Cisco products are available at
http://www.cisco.com/go/warranty.
For More Information
For more information on Cisco Small Business products and solutions, visit:
http://www.cisco.com/smallbusiness.
Printed in USA C78-502441-00 11/08