ClareOne CLR-C1-GB-10 User manual

Installation Manual
ClareOne Glass Break Detector
CLR-C1-GB-10
RF-CLR-C1-GB-10 IM V1 05042020
Description
The CLR-C1-GB-10 is a glass break detector
designed to detect breaking glass made by an
intruder breaking a window. The glass detector
contains an acoustic detection device that
detects sounds when glass is broken. The
detection circuit uses an omni directional
microphone to maximize coverage.
When activated, the detector transmits a signal
to the Clare control panel. The signals the unit
provides are: supervisory, tamper and low
battery (as needed). The detector is powered by
(2) replaceable 3-VDC, lithium CR123A.
Installation Guidelines
The maximum detection range is 20' (6 m) for
plate, tempered, laminated and wired glass.)
Coverage is measured from the sensor to the
point on the glass farthest from the sensor (see
D and D' in Figure 2 below).
Note: The Glassbreak Detector may not consistently
detect cracks or breaks in glass. Glassbreak
Detectors should always be backed up by additional
methods of interior protection.
•For best detection, avoid installing in rooms
with lined, insulating, or sound deadening
drapes or rooms with closed wooden
window shutters inside.
•Do not use near an air conditioner; a blast of
air may cause a false alarm.
•Avoid stairwells, glass booths and all rooms
smaller than 10’ x 10’ (3m x 3m).
•Do not install in humid rooms, excessive
moisture can possibly damage the circuit
board.
Mounting
Screw Mount
1. Remove the detector base from the detector.
2. Place the detector base in desired location
and mount the base with the supplied screws.
Attach the detector to the base.
Testing
LED’s
Yellow flashing –low battery
Red –Wake-up and Alarm
•Test mode is entered automatically when
batteries are inserted. The LED activates on
glass simulator activation and goes out upon
device restoral.
•LED is functional only in test mode.
•Test mode is active for 1 minute and is
extended each time the glass is activated.

Installation ManualClareOne Glass Break
Detector CLR-C1-GB-10
RF-CLR-C1-GB-10 IM V1 05042020
Batteries must be removed and re-installed to
initiate test mode after expiration. (See battery
replacement for removal of batteries).
Glass Break Tester
The glass break detector is designed to detect
the breaking of framed glass. A
Glass Break tester should be used to verify the
detector is in a proper location and can detect
breaking glass.
1. Hold the tester near the surface of the glass
and behind any closed drapes or blinds, aim
the tester at the detector and press the test
button.
2. Watch the LED on the detector, if it detects
the breaking glass sound the Red LED will
light steady and the device will transmit an
alarm.
Programming
The following steps describe the general
guidelines for programming the detector into
panel memory. Refer to the specific panel’s
documentation for complete programming
details.
1. Enter panel learn-in/enrollment mode.
2. Trip tamper switch or enter detector ID
number.
3. Enter detector information.
5. Exit program mode.
Battery Replacement
1. Remove detector cover by pressing on the
latch and pulling the cover off.
2. Insert new batteries observing polarity.
3. Replace detector cover.
Note: If a low battery alarm occurs, replace the
battery within 7 days.
Battery life depends on how often the detector
transmits signals, but is more dependent on the
temperature of the installation environment.
When the battery voltage gets low, the detector
transmits a low battery signal to the panel. The
panel then activates trouble beeps to notify the
customer that the detector battery must be
replaced. Pressing the status button identifies
the detector with the low battery.
Replace the battery immediately when this
condition occurs, using the following battery:
Panasonic CR123A 3V
Battery Disposal
The batteries used in this detector are lithium
batteries and are not reusable. Be sure to
properly dispose of used lithium batteries
according to your local hazardous waste
disposal laws.
CAUTION: Battery may explode if mistreated.
Do not recharge, disassemble or dispose of in
fire.
Specifications
Model no.
RF frequency
Compatibility
Battery type
Battery
Operating
temperature
range
Storage
temperature
range
Relative
humidity
Dimensions (L
x W x D)
CLR-C1-GB-10
433.95 MHz
Clare Control Panels 433.95
MHz
(2) 3-VDC, lithium batteries
(Model CR123A)
Varta CR123A
Panasonic CR123A
32 to 120°F (0 to 49°C)
-30 to 140°F (-34 to 60°C)
95% non-condensing
2.25 x 1.0 x 0.50 in.

Installation Manual
RF-CLR-C1-GB-10 IM V1 05042020
ClareOne Glass Break
Detector
CLR-C1-GB-10
FCC / IC Statement
This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation.
Per FCC 15.19(a)(3) and (a)(4) this device
complies with part 15 of the FCC Rules.
Operation is subject to the following conditions:
(1) this device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesirable operation.
Per FCC 15.21, The user manual or instruction
manual for an intentional or unintentional
radiator shall caution the user that changes or
modifications not expressly approved by the
party responsible for compliance could void the
users authority to operate the equipment.
This equipment generates, uses and can radiate
radio frequency energy and, if not installed and
used in accordance with the instructions, may
cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful
interference to radio or television reception,
which can be determined by turning the
equipment off and on, the user is encouraged to
try to correct the interference by one or more of
the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the
equipment and receiver.
•Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
•Consult the dealer or an experienced
radio/TV technician for help.
This device complies with Industry Canada
license-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this
device may not cause interference, and (2) this
device must accept any interference, including
interference that may cause undesired operation
of the device.
Cet appareil est conforme avec Industrie
Canada exempts de licence standard RSS (s).
Son fonctionnement est soumis aux deux
conditions suivantes: (1) cet appareil ne doit pas
provoquer d'interférences et (2) cet appareil doit
accepter toute interférence, y compris celles
pouvant causer un mauvais fonctionnement de
l'appareil.
In accordance with FCC requirements of human
exposure to radio frequency fields, the radiating
element shall be installed such that a minimum
separation distance of 20 cm is maintained from
the general population.
FCC: 2ABBZ-RF-GB-433
IC: 11817A-RFGB433
This Class B digital apparatus complies with
Canadian ICES-3B.
Cet appareil numérique de la classe B est
conforme à la norme NMB-003 du Canada.
MANUFACTURER HEREBY DISCLAIMS ALL
WARRANTIES AND REPRESENTATIONS,
WHETHER EXPRESS, IMPLIED, STATUTORY
OR OTHERWISE INCLUDING (BUT NOT
LIMITED TO) ANY WARRANTIES OF
MERCHANTABILITY OR FITNESS FOR A
PARTICULAR PURPOSE WITH RESPECT TO
THESE PRODUCTS AND ANY RELATED
SOFTWARE. MANUFACTURER FURTHER
DISCLAIMS ANY OTHER IMPLIED
WARRANTY UNDER THE UNIFORM
COMPUTER INFORMATION TRANSACTIONS
ACT OR SIMILAR LAW AS ENACTED BY ANY
STATE.
(USA only) SOME STATES DO NOT ALLOW
THE EXCLUSION OF IMPLIED WARRANTIES,
SO THE ABOVE EXCLUSION MAY NOT
APPLY TO YOU. THIS WARRANTY GIVES
YOU SPECIFIC LEGAL RIGHTS AND YOU
MAY ALSO HAVE OTHER LEGAL RIGHTS
THAT VARY FROM STATE TO STATE.
MANUFACTURER MAKES NO
REPRESENTATION, WARRANTY, COVENANT
OR PROMISE THAT ITS ALARM PRODUCTS
AND/OR RELATED SOFTWARE (I) WILL NOT
BE HACKED, COMPROMISED AND/OR
CIRCUMVENTED; (II) WILL PREVENT, OR
PROVIDE ADEQUATE WARNING OR
PROTECTION FROM, BREAK-INS,
BURGLARY, ROBBERY, FIRE; OR (III) WILL
WORK PROPERLY IN ALL