Clarke MAJESTIC User manual

USER GUIDE
GC0710
Classic Cast Iron Stove
MAJESTIC
PART NO: 6909905

2
INTRODUCTION
Thank you for purchasing this CLARKE Classic Cast Iron Stove.
Before attempting to install or use the stove, please read this manual
throughout and follow the instructions carefully. Thoroughly familiarise yourself
with this stove & it’s operation in order to ensure the safety of yourself and
others around you. Henceforth, you can look forward to the stove giving you
long and satisfactory service.
GUARANTEE
This product is guaranteed against faulty manufacture for a period of 12
months from the date of purchase. Please keep your receipt which will be
required as proof of purchase. This guarantee is invalid if the product is found
to have been abused or tampered with in any way, or not used for it’s
intended purpose.
Faulty goods should be returned to their place of purchase, no product can
be returned to us without prior permission. This guarantee does not effect
your statutory rights.
PRODUCT SPECIFICATION
Please note that details and specifications contained herein, are correct at the time of
going to print. All data is applicable to wood burning use only. CLARKE International
reserve the right to change specifications at any time without prior notice.
CITSEJAM
rebmuNtraP5099096
thgieWgk5.071
)dxhxw(snoisnemiD mm244x017x596
ycneiciffE%9.57
leuF laoC/dooW
tuptuOtaeHlanimo
N )UTB697,74(wk41
tuptuOgnitaeHecapS )UTB697,74(wk41
negyxO%31@OCderusaeM%91.0
noitarepO tnettimretnI

5
UNPACKING & ASSEMBLY
UNPACKING
Before assembling, please check contents against the following list and
advise your dealer immediately if any parts are missing. Refer also to parts list
& diagram on pages 23 & 24.
1 x Stove body
4 x Legs
1 x Ash-pan & Handle
1 x Flue Collar c/w Fireproof Gasket
1 x Retainer Bar
1 x Baffle Plate
1 x Fixings Kit
1 x Pair of Gloves
TOOLS REQUIRED
13mm spanner
10mm spanner
Clarke Fire Cement
A full range of flue pipes and fire cement is available from your Clarke dealer.
WARNING: DUE TO THE WEIGHT OF THE STOVE IT IS ESSENTIAL THAT TWO
PEOPLE PERFORM THE UNPACKING AND ASSEMBLY.
Unpack the stove and remove
packing materials. Open the doors
and remove the ashpan, legs, flue
adaptor and fixings kit from inside
the stove.
1. Place the stove on a soft surface
such as the polystyrene packing
materials from the crate and tilt
the stove back.
2. Attach the legs using the bolts
and washers supplied as shown
in Fig 1.
FIG 1

6
Fig 2
Fig 3
3. Sit the stove upright and attach
the flue adaptor as shown in Fig 2
using the nuts supplied. Ensure the
fireproof gasket is correctly
seated in the base of the flue
adaptor.
4. Check that the blanking plate is
installed in the rear panel of the
stove when the normal flue exit is
required.
• If the rear mounting flue
configuration is to be used,
the blanking plate will be
fitted to the top of the stove
and the flue connector to the
rear panel.
5. Set the ashpan in position as
shown in Fig 3. A handle is
supplied for when the stove is
in use.
6. Place stove in the desired
location as shown in
POSITIONING AND
INSTALLATION. Take care not
to damage the floor surface.