CLARTE LIGHTING 601LED-PAR16 Series User manual

SMR1-601-NC-PAR16
Installation Instructions ( New Construction)
Black
Black
White
White
Ground Ground
Wiring Diagram
Transformer Power
Install xture frame above ceiling (lines 1-4)
1. Cut a 3 1/4” Dia. Hole in Ceiling tile
2. Insert two hanger bars into the slots located on either side of the plaster frame.
The nail-in tabs point away from the xture. Repeat on the other side.
3. Fasten the hanger bars to the joist using screws or nails. The bottom of the bars should be ush with the
bottom of the joist. Slide the xture along the hanger bars to desired position and secure by depressing
one set of the plaster frame prongs together.
4. Feed the ex with the supply wires to the junction box. Make your electrical connections Black to
Black / White to White and replace snap-lock cover.
www.clartelighting.com 975 N. Todd Ave. Azusa, CA 91702 Tel. No. [phone] Fax No. [phone]
READ AND FOLLOW ALL SAFETY AND INSTALLATION INSTRUCTIONS CAREFULLY.
TURN OFF ELECTRICAL POWER BEFORE STARTING INSTALLATION.
SAVE THESE INSTRUCTIONS

5. Pull Transformer Pig Tail through opening
Series 601LED-PAR16
Installation Instructions ( New Construction)
6. Connect LED pigtail with Transformer pigtail.
7. Tighten screws to secure LED xture to ceiling opening.
www.clartelighting.com 975 N. Todd Ave. Azusa, CA 91702 Tel. No. [phone] Fax No. [phone]