Classic Exhibits visionary DISIGNS MOD-1410 User manual

www.classicexhibits.com
Step 1
Page 1 of X
866.652.2100
© 2015
WHEN DISASSEMBLING ALUMINUM EXTRUSION, TIGHTEN ALL
SETSCREWS AND LOCKS TO PREVENT LOSS DURING SHIPPING
Order #XXXXX -
5
6A
6
5A
When assembled
**Slide A1 L Bracket into TSP50
extrusion and secure with set screws.
A1
TSP50 w/ A1 L Bracket Attachment
*
*
*
*
*
Tighten set
screw to secure
A1
A1
Tighten set
screw to secure
1
2
3
3
4
44
4
Plugs into inside of counter to
supply power for USB chargers.
Plugs into inside of counter to
supply power for USB chargers.
Item
1
2
3
4
5/5A
6/6A
Qty.
1
1
1
4
1/1
1/1
Description
Base Plate
43.5”h Vertical Extrusion
Counter Bottom
12”w Z45 Horizontal Extrusion
20”w Horizontal Extrusion
30”h Vertical Extrusion
Steps:
1) Attach base plate [1] to vertical extrusion [2].
2) Slide Counter Bottom [3] over vertical [2].
NOTE: The counter bottom will be “free floating”
until counter top is attached.
3) Connect horizontals [4] to vetical [2].
4) Place counter top on assembled pedestal base;
attach to [3] using bolts provided
5) Attach horizontal extrusion [5] to vertical [2].
6) Connect vertical extrusions [6] & [6A] to
lower horizontal [5].
7) Attach upper horizontal [5A] to lower
frame assembly.
8) Plug power cord into power source.
MOD-1410 Assembly

www.classicexhibits.com
866.652.2100
© 2015
WHEN DISASSEMBLING ALUMINUM EXTRUSION, TIGHTEN ALL
SETSCREWS AND LOCKS TO PREVENT LOSS DURING SHIPPING
Order #XXXXX - General Information
DO NOT USE POWER TOOLS
ALL CONNECTIONS MUST
BE TIGHTLY SECURED
Part Identification - Numbering
Spline Connection Base Plate & Extrusion Connection
General Setup Instructions
- Read entire setup instruction manual prior to
unpacking parts and pieces.
- The setup instructions are created specifically
for this configuration.
- Setup instructions are laid out sequentially in
steps, including exploded views with detailed
explanation for assembly.
WARNING
Cleaning & Packing
- For Cleaning Metal, Plex, & Laminate Parts:
Use a MILD NON-ABRASIVE cleanser and
soft cloth/paper towel to clean all surfaces.
- Keep exhibit components away from heat
and prolonged sun exposure.
Heat and UV exposure will warp and
fade components.
- Retain all provided Packing Materials.
All provided packing materials are for
ease of repacking & component protection.
Disassembly
- For loss prevention, tighten all setscrews
and locks during disassembly
7A
Hex Tool - Essential for Assembly
Extrusion & Lock Connection Engaged Lock
LADDERS OR LIFTS
MAY BE REQUIRED

www.classicexhibits.com
866.652.2100
© 2015
WHEN DISASSEMBLING ALUMINUM EXTRUSION, TIGHTEN ALL
SETSCREWS AND LOCKS TO PREVENT LOSS DURING SHIPPING
Order #XXXXX - XXXXXXXXXXXXXXXXXXXX