Coleman AKTIV SOUNDS CBT15 User manual

Powering CBT15 On / Off
Slide the ON/OFF switch to ON. You will hear an
audible tone. A blue LED will flash every second
to indicate that it is powered on and searching
for a Bluetooth source to pair with.
To power the speaker off, slide the power switch
to off.
NOTE: The speaker will automatically power
off after several minutes if the Bluetooth
connection is not paired with a device.
NOTE: An additional battery icon will appear
next to the Bluetooth icon at the top right of your
phone/tablet’s screen, indicating the speaker’s
battery level. This is compatible only with
certain devices.
Connecting CBT15 via Bluetooth
Once powered on, the speaker will automatically
enter pairing mode. Go into your phone/tablet’s
Bluetooth settings and enable Bluetooth. Next,
enter the Bluetooth device list and select
Coleman_CBT15. After selected, wait a few
seconds for the pairing to complete. Once the
pairing is successful, you will hear and audible
tone from the speaker and a blue LED will begin
flashing every few seconds.
NOTE: The CBT15 will automatically connect
to a previously paired device if the paired
device’s Bluetooth radio is powered enabled and
within reachable distance.
Connecting CBT15 via Auxiliary Input
If you would like to use a device that is not
equipped with Bluetooth technology, simply
connect the included auxiliary 3.5mm cable from
your device to the Aux-In input at the base of the

CBT11. Bluetooth audio will mute while a
3.5mm cable is plugged in.
Controlling the Sound on Your CBT15
PLAY / PAUSE
Tap the play/pause/handsfree button
VOLUME UP / DOWN
Press and hold the + or –buttons to increase or
decrease the volume
FORWARD /BACKWARD TRACK
Tap forward button to skip a track forward. Tap
the back button to go to the previous track
Answering or Making Calls
If there is an incoming call on your paired
phone/tablet, the music will pause and the ringer
will ring through the CBT15 speaker. To answer
a call, simply press the handsfree button.
To end a call, simply press the handsfree button.
Press the handsfree button twice to redial the
last number called.
NOTE: For best performance and clarity,
operate the CBT15 within an arm’s length.
Ensure that the microphone faces your direction.
Charging your CBT15
Simply plug the included USB cord into the USB
port at the base of the speaker. Once plugged
in, the LED will illuminate RED. It will turn off
once the internal battery is fully charged.
Preserving the Waterproof Seal
Ensure that the back compartment door is fully
pushed in. This will prevent any dust and
moisture from entering the USB and AUX ports.

Factory Reset
If you are experiencing connectivity issues, you
may need to perform a hard reset on your
CBT15. To do so, press the handsfree button
for four seconds. An audible tone will sound,
followed by the LED flashing blue. Once reset
successfully, the LED indicator will flash every
second and will enter pairing mode.
Specifications
Bluetooth Version: 4.1
Built-in Lithium-Ion Battery: 3.7V, 400mAh
Charging Voltage: 5V
Speaker: 52mm 4Ω 3W
Frequency: 150Hz-18KHz
Distortion: ≤0.5%
Effective Distance: 10M
Waterproof Grade: IP54

Elite Brands Inc., 40 Wall Street, 61st Floor
New York, NY 10005 · Tel: [phone]
www.colemanoptics.com
Coleman, , are registered trademarks of
The Coleman Company, Inc. used under license
©2016 The Coleman Company, Inc.
The word mark and logos are registered trademarks
owned by the Bluetooth SIG, and any use of such marks
by Elite Brands Inc. is under license. Other trademarks and
trade names are those of their respective owners.