Coleman 2000008679 Manual

STITCH LINE
Fig. 4
Fig. 5
Fig. 3
Fig. 6
Screenhouse
Stake
Webbing Loop
Lock Button
MODEL 2000008679
SCREENHOUSE SETUP INSTRUCTIONS
Before you begin
• Read all instructions before set up.
• Select a level site clear of rocks, branches, and other hard or
sharp objects, to install your screenhouse.
WARNING: Keep clear of overhead power lines.
• Do not set up your screenhouse under trees because of potential
lightning strikes or falling tree limbs in inclement weather.
• Secure with all stakes and guylines provided to prevent property
damage or personal injury.
• For best results in windy conditions, position narrow end of
screenhouse into the wind.
• Do not drop screenhouse.
• Do not bounce screenhouse bag on its end to remove
screenhouse, as these actions may damage the frame.
• THIS RECREATIONAL PRODUCT REQUIRES A MINIMUM OF TWO
PEOPLE TO ASSEMBLE.
• Under no circumstances should this product be used to cover
automobiles, marine products or similar items.
CAUTION: Avoid pinch points when opening and closing the
screenhouse frame.
(continued on other side)
Extend the Screenhouse
Frame
Raise the Screenhouse
• Stand the screenhouse upright with the hub assembly at
the top. (Fig. 1)
• Unfold the arms of the screenhouse downward until they
lay flat on the ground. (Fig. 2)
• Fully extend the arms of the screenhouse away from the
center hub till the telescoping pole sections are locked in
place. (Fig. 3 and Fig. 3A)
• Extend each of the telescoping leg poles until they snap
into place. The screenhouse will raise as the leg poles are
extended. (Fig. 4)
1
2
Stake the Screenhouse
• Secure screenhouse by driving stakes through the
webbing loops sewn to the screenhouse base.
(Fig. 5 and Fig. 6 )
• Keep the floor taut.
3
Description Description Repair Kit Repair Kit
Plastic Clip 16 mm
Plastic Clip 20 mm
Fabric Repair Kit
Plastic Corner Joint
Fabric Joint Cover
5010000845
5010000846
5010000852
5010000853
5010000855
Fig. 1 Fig. 2
Fig. 3A

STITCH LINE
Guyline
Stake
Fig. 8
Fig. 7
4010010822 (ECN20016987-02)
TheColemanCompany,Inc.•3600NorthHydraulic•Wichita,Kansas67219U.S.A.
1-800-835-3278•www.coleman.com
MADE IN CHINA
© 2011 The Coleman Company, Inc. All rights reserved.
Coleman®, , and are registered trademarks of
The Coleman Company, Inc.
This tent meets the flammability requirements of CPAI-84. The
fabric may burn if left in continuous contact with any flame source.
The application of any foreign substance to the tent fabric may
render the flame-resistant properties ineffective.
WARNING: KEEP ALL FLAME AND HEAT SOURCES
AWAY FROM THIS TENT FABRIC.
Things You Should Know:
• Under certain conditions (cold weather, high humidity, etc.)
condensation will form on the inside of your screenhouse.
Condensation is caused by water vapor from your breath,
perspiration, or any wet clothing inside the screenhouse. It is NOT
LEAKAGE through the screenhouse fabric.
• Tree limbs, tree sap, bird droppings, or moisture steadily dripping
off tree limbs can cause damage to the screenhouse fabric and
its coating resulting in leaks or loss of flame-resistant properties.
• Never store screenhouse, even for a short period of time, without
drying it thoroughly and brushing off caked dirt. Do not pack
stakes inside your screenhouse. Use a separate storage bag.
• Stakes should be removed by pulling on the stake itself. NEVER
PULL ON THE SCREENHOUSE TO REMOVE STAKES AS THIS COULD
RESULT IN PROPERTY DAMAGE OR PERSONAL INJURY.
• Do not leave your screenhouse set-up for weeks at a time. Be
aware that exposure to ultraviolet rays from the sun can seriously
damage material and/or cause it to become discolored.
• This product is not intended to be used during heavy rain, wind,
hail, snow or other inclement weather. Excess water build-up
can cause the frame system to become unstable, and possibly
collapse, causing injury.
• The screenhouse should be taken down and placed in storage
during windy conditions to avoid damage to product or personal
injury.
• DO NOT use gas or flame sources under or near this product.
1. All stakes must be placed in the storage bag to prevent
damage to the fabric items placed in the carry bag.
2. Make sure all components are clean and dry before
placing in carry bag.
3. Store in a clean, dry area.
To Store
Disassembly
To take down the screenhouse, follow the previous steps
and illustrations in the reverse order:
• Remove guylines and stakes. (Fig. 7 and 8)
• Lower the frame one leg pole at a time by pushing the
lock buttons and collapsing the telescoping leg poles.
(Fig. 4)
• Retract the arms of the screenhouse toward the center
hub. (Fig. 3)
• Collapse the screenhouse by folding the arms upward
until the screenhouse stands upright with the hub
assembly at the top. (Fig. 1)
• Place the screenhouse in the carry bag for storage.
TIP: After collapsing the screenhouse, place it on its side,
then roll it multiple times with pressure to reduce its size.
This will allow the unit to slip into the carry bag.
Secure the Guylines
• Attach and stake out guylines. (Fig. 7 and Fig. 8)
• Adjust sliders to make guylines tight.
45
6