Collectors Showcase CS25279 User manual

SHOWCASE
Collector
’
sCollector
’
s
SHOWCASE
Collector
’
sCollector
’
s
SHOWCASE
Collector
’
sCollector
’
s
CLICK!
THE LAMPS NOT ONLY SWIVEL,
THE LAMP HEIGHT CAN ALSO BE
ADJUSTED BY ROTATING THE FLANGE.
PRO TIP
1:18 SCALE ILLUMINATED
DISPLAY CASE (CS25279)
Assembly tips:
• Review assembly instructions
before starting
• Work on a soft, clean surface
• Remove protective lm prior to
assembly
USE SURGICAL OR SOFT CLOTH GLOVES
DURING ASSEMBLY TO AVOID HAVING
TO CLEAN FINGERPRINTS LATER.
PRO TIP
IN THE BOX
1. 1 ASSEMBLING THE SPOTLIGHTS
12x
4x
2x2x1x 1x
2x2x
1x
1x
On the underside of the base, there are two covered
compartments. Insert a small tool (ie. paper clip,
toothpick ) into the holes in the covers and lever up the
two magnetic covers from the bottom of the base.
Pass the lamp wires through the base
mount hole. Slide the wing nut over the
clip and wires. Tighten the wing nut to
secure the lamp in the desired position.
Attach the lamp wires to the
base wires by inserting the base
wire clip into the lamp wire clip.
1. 2 ASSEMBLING THE SPOTLIGHTS
1. 3 ASSEMBLING THE SPOTLIGHTS

CLICK!
CLICK!
2 ASSEMBLING THE SIDES
3 ATTACHING THE TOP
4 FINISHING UP
Cleaning and maintenance:
We recommend using a lint free microber towel. We recommend Brillianize or Novus. You can also use
a solution of mild dish soap and water. These are safe for plastics, and you can even purchase solutions
that help minimize the appearance of any scratches.
DO NOT USE: Ammonias, All Purpose Cleaners, Abrasives, Dry Cloths, Aromatic Cleaners, Windex
Replace both covers by aligning and
facing the cover magnets to the base
magnets. The covers will snap in place.
8x8x
4x4x
FOR EASY TOP ACCESS,
DO NOT PIN TOP.
PRO TIP
ASSEMBLE ALL FOUR SIDES
BEFORE CONTINUING
1. 4 ASSEMBLING THE SPOTLIGHTS
Neatly tuck the connected
wires into the compartment.
Ensure that the wires or the
lamp post do not extend
beyond the compartment.
IF PINS ARE DIFFICULT TO CLICK INTO
PLACE, USE THE ERASER END OF A
PENCIL TO HELP APPLY PRESSURE.
PRO TIP
Attach USB C cable to base and wall
plug. Plug the wall plug into your outlet.
Operate the spotlights using the switch on
the base next to the USB C port.
THIS DISPLAY IS DESIGNED TO BE REVERSIBLE.
SPOTLIGHTS CAN BE IN FRONT OR BEHIND DEPENDING
ON WHAT BEST SUITS YOUR COLLECTIBLE.
PRO TIP