
1551 E. 11th Street, Loveland, CO 80537| 970-667-1000 | 970-667-1032 (fax) | 800-287-0653 | www.coloradotime.com | customerservice@coloradotime.com
F1033 Rev. 201703
Instructions:
1. Move the treadmill by lifting the front and rolling it on the
back wheels.
2. Set it on the deck near the edge of the pool, making sure it
is stable.
3. Open it, by pressing the two back studs at same time to
dislodge the bar. (See image below).
4. Lift bar into place and then push
towards treadmill base until it locks in
place
5. Put WaterFit Treadmill in pool and
make sure that it is secured with suction
cups. Check that it is stable.
6. You can use WaterFit Treadmill.
7. To remove it, loosen suction cups
from bottom of pool.
8. Remove treadmill from pool and
let the water drain out.
9. Place it on the pool deck.
10.To fold bar, pull it up, then rotate
it down.
11.To prevent the bar from moving,
press two black studs and reinsert bar
into its slot (behind two black studs).
12.Clean treadmill after each use
with soap and to rinse it with clear (not
pool) water.
13.You can move and store device in
a dry place at room temperature.
Warning:
Check that WaterFit Treadmill is firmly fixed to pool floor with suction cups and that the floor is flat
and the treadmill is stable. Treadmill must be used horizontally. Bar must be securely locked before
using treadmill.