COMPANION COMP7012 User manual

companionleisure.com.au
companionleisure.com.au
POWER COOKER & STOCKPOT SET
Instruction Manual
Part No. COMP7012
IMPORTANT
Read these instructions for use carefully. Familiarise yourself with the appliance before
connecting it to its gas container. Keep these instructions for future reference.
AS 2658:2008
Cert. GSCS20238
SAI Global

2
GENERAL WARNINGS
• This appliance shall only be connected to a cylinder with
a POL gas cylinder valve certied to AS2469 standards.
• This appliance is designed for outdoor use only and
must be operated a minimum of 1500mm from any
ammable material or surfaces and materials.
• This appliance is to be stored in a dry and well
ventilated location free from direct sunlight.
• Do not store when valve is still connected to the
cylinder.
• Make sure that the cylinder is disconnected and
is stored in a well ventilated area, free from direct
sunlight, heat and ignition sources.
• If cylinder is being stored indoors, ensure that the
indoor storage location complies with the standard
AS / NZS1596
• This appliance must only be serviced by an authorised
service agent, return to your place of purchase for
service and repair.
IMPORTANT
Read these instructions for use carefully.
Familiarise yourself with the appliance before
connecting it to a gas container.
Keep these instructions for future reference.
DANGER!
• During operation all surfaces will be extremely hot and
should not be touched or handled.
• Do not use the appliance if it has a leak, worn,
deteriorated or damaged seals.
• Handle with care even after brief use, always pick up
using the legs not the cylinder.
• It may be hazardous to attempt to t other types of gas
containers or cartridges.
• Use only in well ventilated areas.
• Always operate appliance a minimum of 1500mm from
ammable materials and walls, and a minimum of
2700mm from ceiling.
• Do not use adaptors or modify appliance to t other
connectors or cylinders.
• Do not modify appliance.
• Do not use multiple appliances to heat a single utensil.
• Children must be supervised by an adult at all times.
• Never leave appliance unattended when operating.
• Use as a cooking appliance only, not to be used as
heater or modied for any other reason.
• Avoid boil over and spills on to burners.
• Not suitable for marine environment.
CARBON MONOXIDE HAZARD
This appliance produces carbon monoxide which has no
odour. Using the appliance in enclosed spaces, for example;
caravan, car, boat or mobile home could cause DEATH.
IMPORTANT
• Keep children away from appliance at all times.
• Surfaces of the appliance will become hot during
operation, please take care when handling or moving
the appliance.
• Do not move appliance during cooking, allow to cool
completely.
• Appliance is to be used on a stable, level, at, non-
ammable surface. The appliance should be protected
from direct drafts and in a well ventilated place.
• Only cooking vessels with a minimum diameter of
220mm and no wider than 350mm diameter are to be
used with this appliance.
• Take care that the control valves and primary air intakes
located on the burner tube of this appliance are not
obstructed, or that air ow is restricted by placing items
or other appliances close to or adjacent to the inlets.
• If you smell gas, immediately turn the gas off at the
cylinder and move the appliance and cylinder to a well
ventilated area outside, keeping well away from sources
of heat such as naked ames and pilot lights.
• Do not attempt to move or relocate the appliance when
it is operating, extinguish the burner and allow to cool,
disengage the gas cylinder then move the appliance.
CHECKING FOR GAS LEAKS
• Check that all connections are tight and that the gas
cylinder connection has been tightened before you turn
the cylinder gas valve on.
• NEVER check for leaks with a ame or pilot light.
• Using soapy water, coat all connections, if bubbles
appear turn the cylinder gas control off and retighten
the connection before re-testing.

3
• Inspect the appliance regularly for signs of wear, leaks
or incorrect operation. If symptoms such as aring of
the burner, issues with lighting, damages to hoses
or connections or leaks from seals or gas controls
are identied do not attempt to repair, return to your
authorised stockist for service and maintenance.
• To check if gas remains in the cylinder, disconnect from
the appliance and hold the cylinder in a vertical position
then shake from side to side, if there is a sound or feel
of liquid movement inside, the cylinder contains gas.
• When changing gas cylinders ensure this is conducted
outside in a well ventilated location free from people,
animals and ignition sources such as naked ames,
pilot lights and electrical equipment with heaters or
elements.
SAFE APPLIANCE LOCATIONS
This appliance must only be used in an above
ground open air situation with natural ventilation,
without stagnant areas, where gas leakage is rapidly
dispersed by wind and natural convection.
Any enclosure in which the appliance is used
should comply with one of the following:
(A) An enclosure with walls on all sides,
but with no overhead cover.
(B) Within a partial enclosure that includes an
overhead cover and no more than two walls.
(C) Within a partial enclosure that includes an overhead
cover and more than two walls, the following must apply:
(1) At least 25% of the total wall
area is completely open.
(2) 30% or more in total of the remaining wall side,
back and front wall areas is open and unrestricted.
(3) In the case of balconies, 20% or more of the total
wall area must remain open and unrestricted.
The following gures are diagrammatic
representations of outdoor areas. Rectangular
areas have been used in these gures - the same
principles apply to any other shaped areas.
1
1
A
B
C
1
2
2

4
REQUIRED TOOLS
Adjustable spanner
PARTS LIST
1. Storage Bag
2. Cooker Frame
3. Pot & Basket
4. LP Hose/Regulator
5. Basket Lifter
6. Heat Reector
7. Burner Assembly & Wing Nut
8. Gas Control Assembly
9. Thermometer
2
3
1
7 9
5
6
8
4

5
1. ASSEMBLY
Review the contents of the package.
Make sure all listed components are included.
1. Install the burner and reector plate into the steel
frame, using the wing nut.
2. Align the male end tting on the Gas Control Assembly
to the venturi tube on the burner and screw in the
internal thread on the burner. Use an adjustable
spanner to tighten until tight.
Take care not to overtighten as this will strip the
thread in the burner tube.
Note:
Once connected, the gas control does not need to be
removed for storage or when packed away.
2. CONNECTION
Your cooker is designed to connect directly to
a gas cylinder with a POL connector using the
specially designed LP Gas hose and regulator.
1. Check that the cylinder
gas control is in the
“OFF” position (turned
fully clockwise)
2. Take the hose and
attach to the gas inlet
on the appliance, tighten
up using a spanner.
DO NOT use ngers to
tighten connection.
3. Attach the other end
of the hose with the
regulator to the gas
cylinder, tightening using
the two nger support
posts.
4. Check that gas control
on cooker is turned
“OFF”, then turn the
cylinder gas valve on
in an anti-clockwise
direction for one full
turn and then check the
connections for leaks
with soapy water.
If a leak is detected
turn the cylinder gas valve “OFF” and retighten all
connections then retest.

6
3. LIGHTING THE COOKER
1. Turn the gas cylinder
valve on in an
anti-clockwise direction
for one full turn.
2. Using long BBQ matches or gas lighter, position close to
the edge of the burner to be ignited, slowly turn the gas
control in an anti-clockwise direction approximately ¼
of a turn.
3. If the burner does not ignite, turn the gas control in the
clockwise direction to the “Off” position and allow the
residual gas to disperse before attempting to reignite
the burner.
Note:
Locate the gas cylinder away from your cooker to ensure
it is not subjected to radiant heat.
4. ADJUSTING HEAT OUTPUT
1. Turn the gas control
in an anti-clockwise
direction to achieve a
higher ame and in the
clockwise direction for a
lower ame.
5. TURNING THE COOKER OFF
If the appliance is no longer to be used and to
reduce the risk of blocked gas jets caused by
excess gas being left in the hose, all remaining
gas must be expelled from the hose assembly.
1. With the ame still
operating, turn the valve
on the gas cylinder in
the clockwise direction
until it is off. Allow the
ame to burn down
then extinguish once
all remaining gas in the
hose has been used.
2. Turn the gas controls on
the appliance clockwise
to the “Off” position.
-
+

7
6. PACKING
When packing the cooker away ensure that it
has cooled and there are no areas of heat.
1. Disconnect the LP Gas hose from the gas control
assembly. The gas control assembly does not need to
be removed from burner tube.
2. Unscrew wing nut on
base of burner and
remove reector plate
and burner assembly
from cooker frame.
3. Place basket inside pot then position cooker frame over
pot and allow to slide inside.
4. Place burner, reector plate, hose and regulator
assembly into the pot and install lid on top the place
inside storage bag.
CARE INSTRUCTIONS
Using warm soapy water with a mild detergent wipe
down all surfaces and areas of the appliance, taking
care not to allow water to enter the burner outlets
or aeration holes located in the burner tube.
DO NOT submerge the appliance in a sink or bowl
DO NOT use abrasive cleaners or bleach
MAINTENANCE AND SERVICE
• During operation if it is noted that the burner ame
is unstable, is changing colour from Blue to Yellow
or has a distinct smell it is important that you take
the appliance to your local authorised gas appliance
repairer for inspection.
• Periodically check the gas control is tight and has no
leaks, follow the testing for leaks procedure. Check
the gas hose & regulator for any signs of wear, cuts or
fraying, if identied replace immediately with a Gas
Certied replacement hose and/ or regulator
• For further information or assistance please contact
customer service.

COM4306
Distributed by
PRIMUS AUSTRALIA Pty Ltd
Bundoora Victoria 3083
www.companionleisure.com.au
For more information contact
Customer Service on 1300 555 197
POWER COOKER & STOCK POT SET
Manufacturer Primus Australia
Part No. COMP7012
Injector size 1.18mm
Consumption 110Mj/hr - 2180g/hr
Size 350L x 350W x 437Hmm
Weight 7.5kg
Certicate Number GSCS20238
SPECIFICATIONS