COMPANION 10000337 User manual

RADIANT LP
GAS HEATER
5,500 BTU
OWNERS MANUAL
Part No. 10000337
AUSTRALIA ONLY
GAS SAFETY CERTIFICATION
TM

2
GENERAL WARNINGS
This appliance shall only be used with a Propane (LPG)
rellable cylinder certied to Standard AS 2469 that has
a 3/8" LH BSP inlet tting.
IT MAY BE HAZARDOUS TO ATTEMPT TO FIT OTHER
TYPES OF GAS CONTAINERS.
ONLY USE IN WELL-VENTILATED AREAS.
CARBON MONOXIDE HAZARD - USING THIS APPLIANCE
IN AN ENCLOSED SPACE MAY CAUSE DEATH. DO NOT
USE IN CARAVANS, TENTS, MARINE CRAFT, CARS,
MOBILE HOMES OR SIMILAR LOCATIONS.
WARNING! USE OUTDOORS ONLY.
CAUTION: accessible parts may be very hot. Keep young
children away.
SAFETY INFORMATION
Inspect the appliance regularly for signs of wear, leaks
or incorrect operation. If symptoms such as aring of
the burner, issues with lighting, damages to hoses
or connections or leaks from seals or gas controls
are identied do not attempt to repair, return to your
authorised stockist for service and maintenance.
Do not modify this appliance.
Check that seals between the appliance and the gas
container are in place and in good condition before
connecting the gas container. See gure 1.
Do not remove the guard protecting the burner from this
appliance.
Do not use this appliance if it has damaged or worn
seals.
Do not use the appliance if it is leaking, damaged or
does not operate properly.
This appliance is to be operated on a stable, horizontal,
non-ammable surface.
The appliance should be protected from direct drafts
and in a well ventilated place.
Gas orices and burner must be kept clear of dirt and
cobwebs. Flow of combustion and ventilation air through
the perforated portions of the appliance must not be
obstructed.
Any cleaning agent used on the appliance must be of a
non-combustible and non-corrosive nature.
IMPORTANT: Read these instructions for use carefully. Familiarise yourself with the appliance before
connecting it to its gas container. Keep these instructions for future reference.

3
RADIANT LP GAS HEATER OWNERS MANUAL
Gas containers shall be changed in a well-ventilated
location, preferably outside, away from people and any
source of ignition, such as naked ames, pilot ame,
electric heaters/equipment.
Return to your place of purchase for spare parts, service
and repair.
This appliance must only be serviced by an authorised
person.
This appliance must be operated away from any
ammable material or surfaces and materials.
Always operate appliance a minimum of 1000mm from
ammable materials, walls and 1000mm from ceiling.
Handle with care even after brief use as some surfaces
may become hot during operation; always allow the
appliance to cool down before moving.
Pick up using the handle only.
Do not use as a cooking appliance or modify for any
other reason.
Ensure all packaging is removed prior to use.
Do not operate this appliance before reading the
instruction booklet.
Do not place articles on or against this appliance.
Do not hang or attempt to dry clothes or any ammable
material on or placed near the appliance.
Do not store chemicals or ammable materials, or spray
aerosols near this appliance.
Do not operate with panels, covers or guards removed
from this appliance.
Do not operate in an enclosed area without ventilation.
Do not operate in a boat, caravan or tent.
CARBON MONOXIDE HAZARD
Using this appliance in an enclosed space may cause DEATH.
Do not use in caravans, tents, marine craft, cars, mobile homes
or similar locations.
Figure 1: O-Ring seal located inside the cylinder connection.

4
CHECKING FOR GAS LEAKS
Check that all connections are tight and that the gas
cylinder connection has been tightened before you turn
the cylinder gas valve on.
If there is a leak on your appliance (smell of gas)
immediately attempt to turn off the cylinder valve.
Remove the appliance to a well-ventilated location away
from any ignition source.
NEVER check for leaks with a ame or pilot light.
Check for leaks using Companion Gas Leak Detection
Spray or soapy water, coat all connections, if bubbles
appear turn the cylinder gas control off and re-tighten
the connection before re-testing.
SAFE LOCATIONS
This appliance shall only be used in an above ground
open air situation with natural ventilation, without
stagnant areas, where gas leakage and products of
combustion are rapidly dispersed by wind and natural
convection.
Any enclosure in which the appliance is used shall
comply with one of the following:
An enclosure with walls on all sides, but with no
overhead cover (see example 1).
Within a partial enclosure that includes an overhead
cover and no more than two walls (see examples 2 & 3)
Within a partial enclosure that includes an overhead
cover and more than two walls, the following shall apply:
at least 25% of the total wall area is completely open.
30% or more in total of the remaining wall side, back
and front wall areas is open and unrestricted
(see examples 4 & 5).
In the case of balconies, 20% or more of the total wall
area shall remain open and unrestricted.
DIAGRAMMATIC REPRESENTATION OF OUTDOOR AREAS
The following examples are diagrammatic
representations of outdoor areas. Rectangular areas
have been used in these examples - the same principles
apply to any other shaped area.
Example 1
Example 2
Example 3
Example 4
Example 5
Both ends open
Open side at least 25% of total wall area.
30% or more in total of the remaining wall area is open and unrestricted.
Open side at least 25% of total wall area.
30% or more in total of the remaining wall area is open and unrestricted.

5
RADIANT LP GAS HEATER OWNERS MANUAL
IMPORTANT INFORMATION FOR USE
During operation all surfaces will be extremely hot and
should not be touched or handled.
Take care that the primary air intakes, located on the
burner tube of this appliance are not obstructed, or that
air ow is restricted by placing items or other appliances
close to or adjacent to the inlets.
Do not attempt to move or relocate the appliance when
it is operating, extinguish the burner and allow to cool,
disengage the gas cylinder then move the appliance.
This appliance is to be stored in a dry and well-
ventilated location free from direct sunlight. Do not store
when still connected to the cylinder.
Make sure that the cylinder is disconnected and is stored
in a well ventilated area, out of the reach of children,
free from direct sunlight, heat and ignition sources. If
being stored indoors, ensure that the location complies
with the standard AS/NZS 1596.
Never leave appliance unattended when operating.
After use, turn the gas cylinder valve off, wait for
the ame to go out, then turn the appliance control
valve(s) off.
To check if gas remains in the cylinder, disconnect from
the appliance and hold the cylinder in a vertical position
then shake from side to side, if there is a sound or feel of
liquid movement inside, the cylinder contains gas.

6
UNDERSTANDING YOUR APPLIANCE
GRILL
BURNER HEAD
NECK TUBE
CARRY HANDLE
PIEZO
PIEZO WIRE
CYLINDER
CONNECTION
REFLECTOR

7
RADIANT LP GAS HEATER OWNERS MANUAL
CONNECTION
Your radiant heater is designed to connect directly on to
a 3/8" LH BSP gas cylinder.
Check that the gas valve on the cylinder is in the OFF
position (turned fully clockwise). See gure 2.
Take the heater and attach to the gas cylinder valve and
tighten. See gure 3.
Turn the cylinder gas valve on in an anti-clockwise
direction for one full turn and then check the
connections for leaks with Companion Gas Leak
Detection Spray or soapy water. If a leak is detected
turn the cylinder gas valve OFF and re-tighten all
connections, then retest. See gure 4.
Figure 2
Figure 4
Figure 3

8
LIGHTING HEATER
Slowly turn the gas cylinder control valve in the anti-
clockwise direction half a turn whilst simultaneously.
pressing the piezo button until the burner ignites.
NOTE:
If the burner head does not ignite, turn the cylinder gas
control valve to the off position, wait for 1 minute then
repeat the previous step.
ADJUSTING HEAT OUTPUT
Turn the gas control in an anti-clockwise direction
to achieve a more intense heat output, this can be
identied by the burner gauze emitting a bright orange/
red colour and in the clockwise direction for a reduced
heat output.
IMPORTANT:
DO NOT open the gas valve beyond the point where
maximum heat intensity is reached as this may result in
unnecessary aring and wasted gas.
A warm up period of 2 minutes is required to ensure that
maximum heat intensity can be achieved.
Avoid moving the radiant heater once lit as this may
result in aring.

9
RADIANT LP GAS HEATER OWNERS MANUAL
TURNING HEATER OFF
Extinguish the heater by turning the gas cylinder control
valve in the clockwise direction until fully closed.
IMPORTANT:
Check that heater is fully extinguished before leaving
unattended.
The heater will be extremely hot and must be moved
to a safe and secure position where it cannot come in
contact with any ammable materials or surfaces.
DISCONNECTING FROM CYLINDER
Check that the heater is fully extinguished, the gas
cylinder control valve is in the fully off position and all
surfaces are cool. Loosen the connection to the gas
cylinder in a clockwise direction.

10
CARE INSTRUCTIONS
Using warm soapy water with a mild detergent wipe
down all surfaces and areas of the appliance, taking
care not to allow water to enter the burner outlets or
aeration holes located in the burner tube.
Do not submerge the appliance in a sink or bowl.
Do not use abrasive cleaners or bleach.
MAINTENANCE AND SERVICE
During operation if it is noted that the burner ame is
unstable, is changing colour from blue to yellow or has a
distinct smell it is important that you take the appliance
to your local authorised gas appliance repairer for
inspection.
Periodically check the gas control is tight and has no
leaks, follow the testing for leaks procedure. Check
the gas connection for any signs of wear or damage, if
identied contact customer service for a replacement
assembly immediately.
For further information or assistance please contact
customer service.
A selection of spare parts and components are available
for your appliance to ensure years of operation.
For more information call 1300 555 197 or
email: [e-mail]
SPECIFICATIONS
Part no. 10000337
Gas type Propane (LPG)
Gas jet size 0.15mm
Gas consumption 5.8MJ/h - 116g/h
Gas pressure Cylinder pressure
BTU output (total) 5,500 BTU
Dimensions 285L x 206W mm
Weight 0.76kg
Certicate number AGA 3023 G
SPARE PARTS LIST
1PCS7156 Grill Assembly
2PCS6045 Burner Assembly
3PCS5023 Gas Jet Small Burner Stove - 2 pack

11
RADIANT LP GAS HEATER OWNERS MANUAL

COM5299
Companion®is a registered trademark of
Primus Australia Pty Ltd
Designed & Imported by:
Adventure Trading Australia Pty Ltd
71 Charles Ulm Place,
Eagle Farm, QLD 4009
AUSTRALIA
Made in China
WARRANTY - For details see www.companionoutdoor.com/warranty