ESI AA330 User manual

INSTALLATION AND USE
AA330
ARTICULATING KEYBOARD ARM
AA330 Rev A 4/17
Model AA330

AA330 ARTICULATING KEYBOARD ARM
PLEASE REVIEW these instructions before beginning the installation. Check that
all parts needed were provided with your order. Contact your supplier if any
operates to your satisfaction.
PARTS PROVIDED
Articulating Arm (1)
Front Stopper (1) 5
/8" Wood Screws (9) 1" Wood Screws (9)
Track (1)
STEP 1: Adhere Track
• Peel the backing from the adhesive
strips on top of the track.
• Adhere the track to the
underside
of the work
— Position the front edge
of the track 1
/4" from the
front edge of the work
surface. The front of the
track is the end with
three holes.
•
Rear
Stop
Peel Off
Backing
Press
Firmly
1
/4"
surface.
2
CAUTION: This install requires a power drill. This is not a hand tool install.
ADDITIONAL TOOLS REQUIRED
• #2 Phillips Screw Driver Bit
• " Drill Bit
• Drill (For Track Installation Only)
1
/8

AA330 ARTICULATING KEYBOARD ARM
STEP 2: Attach Track
• Drill 1 /8" pilot holes through all
nine holes in the track.
— Drill the holes 5/8" deep or 1"
deep, depending on which
wood screws will be used. (A
minimum work surface thickness
of 11
/2" is recommended for the
1" screws.)
CAUTION: Be careful not to drill through the
work surface.
• Attach the track with screws through the six rear
holes only, as shown.
STEP 3: Install Articulating Arm
• Slide the articulating arm onto
the track. Position it back far
enough so that you have access
to the front three holes on the
track.
STEP 4: Attach Front Stop
• Position the front stop onto the
front of the track and secure it
Attach Through Rear
Six Holes Only
Slide Back
Front
Stop
3

© 2017 ESI Ergonomic Solutions. All rights reserved. AA330 Rev A 4/17
AA330 ARTICULATING KEYBOARD ARM
800.833.3746 esiergo.com
OPERATION
To Raise or Lower:
• Tip the platform up to unlock.
• Move the arm to the desired height.
• Release the platform to lock it in place.
To Set Tilt Angle:
• Unlock the quick release handle on the right side of the arm.
• Adjust the tilt angle to the desired position.
• Lock the quick release knob.