Confer Plastics Leisure Accents User manual

Assembly Instructions
By Confer Plastics
30” Patio Table
Stools shown - optional
Leisure Accents
Leisure Accents

E-mail: [email protected]
Note: For missing or replacement parts, please visit our website at www.conferplastics.com
30” Patio Table
P
arts List
1 – Table Top
1 – Full Leg
2 – Half Leg
1
. With the Full Leg and Half Leg in the upside down position (Figure 1), slide the groove in
the Half Leg over the tongue in Full Leg as shown (Figure 2). Note that the opposite end will
not be secure until it is inserted into the Table Top later in the assembly process (Figure 3).
2.
While keeping the tongue and groove joint tight (Figure 4), slide the groove in the second
Half Leg over the tongue in the Full Leg (Figure 5).
If desired, add weight to the legs before
final assembly by removing the plugs, located on the top edge of each leg, pour in a small
amout of sand, and replace the plugs.
See other side
Table Top Full Leg Half Leg
Figure 1 Figure 2 Figure 3
Figure 4 Figure 5
Leisure AccentsLeisure Accents

Figure 6
Snap Lugs
Figure 7 Figure 8
3
. With the leg assembly upwards as shown in (Figure 6), place the table top over the legs
and loosely align the eight snap lugs into the corresponding holes in the underside of
the table top as shown in (Figure 7). Starting at one of the outermost lug positions strike
the table top with a mallet as shown in (Figure 8). Then proceed to hit the four inner lug
locations and finally the outer three lug locations.
30” Patio Table
Leisure AccentsLeisure Accents

Made in the USA by
CONFER PLASTICS, INC.
97 WITMER ROAD
NORTH TONAWANDA, N.Y. 14120-2421
www.conferplastics.com
e-mail: [email protected]
PRINTED IN USA
LAPT 12/04