Connects2Vision CAM-16 User manual

Image Sensor 1099 HD CCD
TV Lines: 480
Resolution: 976 x 496
Lumen: 0.1 Lux
Horizontal Angle: 170 Degrees
Vertical Angle: 120 Degrees
TV System: NTSC/PAL
Video Output: 1.0V p-p 75ohm
Operating Voltage: 12V DC (Negative Ground)
Current Consumption: 120mA @ 13.8V
Waterproof Rating: IP68
Operating Temperature: -20 Degrees C to +70 Degrees C
Parking Lines: Yes
Removable Lines: Yes
Image Adjustment: Yes (Mirror/Normal)
Enhanced Performance In Low Light: Yes
User Manual
Prior to Installation
Read the manual prior to installation. Technical knowledge is necessary for installation.
Please ensure you use the correct tools to avoid damage to the vehicle or product.
Connects2 can not be held responsible for the installation of this product.
Technical Support
Connects2 want to provide a fast and suitable resolution should you encounter any tech-
nical issues. With this in mind, when contacting Connects2, try to provide as much Infor-
mation as possible. This will speed up the process and help us to help you.
Please use our dedicated online technical support centre: support.connects2.com
Universal Camera
Surface Mounted in Smooth Squared Plastic Housing
PRODUCT FEATURES:
DISCLAIMER:
CAM-16

www.connects2.com
2
Connects2Vision
CONTENTS
- Camera with mounting points and 1m cable to mini Male 6 pin connector
- 1m camera connection cable with mini Female 6 pin connector and RCA Female
connector
- 6m Male to Male RCA extension cable
- Instructions
INSTALLATION
1. Connect the Black wire to a suitable ground and the Red wire to a switched
+12V supply.
2. If the camera is to be used in the rear of the vehicle, the Red wire should be con-
nected to the reversing light circuit or an interface which provides a reverse signal.
3. Select a suitable location for the camera and ensure that the area is free from all
cables, fuel & oil. Whenever possible, avoid locations that are subject to road dirt &
water spray.
4. Using the camera mounting points, mount the camera in the required position on
the vehicle.
5. Using the supplied video cable, connect the camera to the display screen and
ensure that the image is displayed correctly.
6. To swap the image from mirror to normal view, cut the small White looped wire
which is located on the camera connection cable.
7. To remove the parking line feature, cut the small Blue looped wire which is locat-
ed on the camera connection cable.
Subscribe to our YouTube Channel for installation
guides and tips... www.youtube.com/connects2