Connects2Vision CAM-MT2 User manual

www.c2vision-eu.com
Image Sensor: 1/3” PC 3089D
TV Lines: 550
Resolution: 728 (H) x 488 (V)
TV System: NTSC/PAL
Waterproof Rating: IP68
Viewing Angle: 160 Degrees
Parking Lines: Yes (Removable)
Image Adjustment: Yes (Mirror/Normal)
Video Output: 1.0V p-p 75ohm
Operating Voltage: 12V DC (Negative Ground)
Current Consumption: 117mA @ 13.8V
Operating Temperature: -20 Degrees C to +70 Degrees C
User Manual
Tailgate Handle Camera
Mitisubishi L200 2008-2015
Black (MT2) / Sliver (MT3)
PRODUCT SPECIFICATIONS
CAM-MT2
CAM-MT3
Prior to Installation
Read the manual prior to installation. Technical knowledge is necessary for installation.
Please ensure you use the correct tools to avoid damage to the vehicle or product.
Connects2 can not be held responsible for the installation of this product.
Technical Support
Connects2 want to provide a fast and suitable resolution should you encounter any
technical issues. With this in mind, when contacting Connects2, try to provide as much
Information as possible. This will speed up the process and help us to help you.
Please use our dedicated online technical support centre: support.connects2.com
DISCLAIMER:

2
Connects2Vision
www.c2vision-eu.com
• Tailgate handle camera with power cable
• 8m extension cable to RCA and power/ground cable
1. Firstly, remove the inner panel from the tailgate and remove the handle xing screws. Then
remove the tailgate handle from the vehicle.
2. Remove the locking mechanism from the factory tailgate handle and ret it into the
replacement handle containing the camera.
3. Attach the camera to the vehicle using the original screws and route the camera cable
through the tailgate and under body to the location of your monitor.
4. Connect the black wire to a suitable ground and the red wire to the reversing light circuit or an
interface which provides a reverse signal.
5. Connect the camera cable to the connection cable and connect the video cable to the display
monitor and ensure that the image is displayed correctly.
NB: The two loops on the camera power cable will activate/deactivate the following features:
Cut Loop Loop Intact
Green Disable parking guidelines Enable parking guidelines
White NTSC PAL
Power cable (hardwired to camera) with
green/white loops
CONTENTS
INSTALLATION