www.connects2.com
2
Connects2Vision
CONTENTS
- Camera with mounting plate and 1m camera cable to mini Male 6pin connector
- Camera connection cable with mini Female 6pin connector, RCA Female
connector and 1m DC power cable
- 6m RCA Male to Male extension cable
- Instructions
INSTALLATION
1. Connect the Black wire to a suitable ground and the Red wire to a switched
+12V supply.
2. If the camera is to be used in the rear of the vehicle, the Red wire should be con-
nected to the reversing light circuit or an interface which provides a reverse signal.
3. Select a suitable location for the camera and ensure that the area is free from all
cables, fuel & oil.
4. Whenever possible, avoid locations that are subject to road dirt & water spray.
5. Mount the camera in the desired location using the supplied mounting plate.
6. Using the supplied video cable, connect the camera to the display screen and
ensure that the image is displayed correctly.
7. Adjustment of the camera may be required to ensure that the correct angle of
the image is achieved.
8. To remove the parking line feature, cut the small Green looped wire located on
the camera connection cable.
9. To swap the image from mirror to normal, cut the small White looped wire locat-
ed on the camera connection cable.
Subscribe to our YouTube Channel for installation
guides and tips... www.youtube.com/connects2
