Cool-Living CL-RAC10EWES-6A User manual

CL-RAC10EWES
CL-RAC10EWES-6A
CL-RAC12EWES
CL-RAC12EWES-6A
WWW.COOLLIVINGPRODUCTS.COM OR EMAIL [email protected]

FCC Caution.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.

FIG. 1
FIG. 2
OFFSET
STOOL
SILL
INTERIOR
WALL
EXTERIOR
WALL
OFFSET
STOOL
SILL
INTERIOR
WALL
EXTERIOR
WALL

FIG. 3
FIG. 4
FIG. 5

FIG. 6
FIG. 7
FIG. 8
FIG. 9
FIG. 10 FIG. 11
FIG. 13

FIG. 14

1
2
3
4
5
6
7
8
9
AUTO
SPEED
AUTO
MODE
TIMER ON: WHEN THE UNIT IS IN STANDBY, PRESS THE TIMER BUTTON TO SET THE TEMPERATURE, THEN PRESS
THE TIMER BUTTON TO SET THE TIMER TO ON, AND PRESS " " AND " " BUTTON TO ADJUST THE SETTING TIME
AS YOU NEED, AFTER THE DISPLAY IS STABLE, PRESS THE TIMER BUTTON TO CONFIRM.

horizontal wheelair deflector air deflector
PRESS THE SLEEP BUTTON, ALL OF THE DISPLAY LIGHTS WILL TURN OFF AFTER A WHILE, BUT
THE SLEEP LIGHT IS ALWAYS ON. IN SLEEP MODE, THE AIR CONDITIONER WILL AUTOMATICALLY ADJUST THE
TEMPERATURE AND FAN SPEED TO MAKETHE ROOM MORE COMFORTABLE DURING THE NIGHT. THE SET
TEMPERATURE WILL AUTOMATICALLY RAISE EVERY 30-60 MINUTES, AND AT MOST CHANGE SIXTIMES UNTIL THE
SET TEMPERATURE IS 81 OR 82 .

1
4
5
6
3
3
7
8
10
9
2
PRESS THE SLEEP BUTTON, ALL OF THE DISPLAY LIGHTS WILL
TURN OFF AFTER A WHILE, BUT THE SLEEP LIGHT IS ALWAYS ON. IN
SLEEP MODE, THE AIR CONDITIONER WILL AUTOMATICALLYADJUST
THE TEMPERATURE AND FAN SPEED TO MAKE THE ROOM MORE
COMFORTABLE DURING THE NIGHT. THE SET TEMPERATURE WILL
AUTOMATICALLY RAISE EVERY 30-60 MINUTES, AND AT MOST CHANGE
SIXTIMES UNTIL THE SET TEMPERATURE IS 81 OR 82 .
TIMER ON: WHEN THE UNIT IS IN STANDBY, PRESS THE TIMER BUTTON TO SET THE TEMPERATURE, THEN PRESS
THE TIMER BUTTON TO SET THE TIMER TO ON, AND PRESS " " AND " " BUTTON TO ADJUST THE SETTING TIME
AS YOU NEED, AFTER THE DISPLAY IS STABLE, PRESS THE TIMER BUTTON TO CONFIRM.

FIG. 15

PAGE 16 OF 16