Coolaroo Melaleuca User manual

CANTILEVER UMBRELLA
MELALEUCA
ASSEMBLY GUIDE AND
OPERATING INSTRUCTIONS

WARNING
When assembling and using this product, safety precautions should always be followed to reduce
the risk of personal injury and damage to equipment.
Please read all instructions before assembly and use.
Two or more people are recommended for safe assembly.
Keep all children and pets away from assembly area.
Install on level ground.
Check all nuts and bolts for tightness before use and regularly during use.
The base must be weighted down. Fill with water to prevent tipping.
This is a non-permanent structure, do not use in extreme weather conditions including heavy rain
or high winds.
Do not leave the umbrella open unattended.
Do not place the product near an open ame or too close to any heat source eg heaters and BBQs.
The diagrams in this manual are for assembly and operation illustration only.
They may dier from the umbrella’s actual appearance.
CARE AND MAINTENANCE
When not in use, close the umbrella, place the umbrella cover over it and
store in a dry place. If the canopy is wet, allow to dry naturally in the open
position before storing.
If necessary, clean the fabric with a hose.
Components subject to turning and sliding can be treated with a non-staining
lubricant spray (silicon-based).

ASSEMBLY GUIDE
STEP 1
Take all of the parts out of box 1 and 2 to ensure they are all present before
starting construction.
3.5m
2.8m
ROUND
3m
2.7m
SQUARE

STEP 2
If you want the base to be portable,
attach the wheels (o) to the underside
of the base (n).
The wheels have a locking function.
Rotate the metal lock to stop the wheels
from turning.
Note: Always lock the wheels to prevent
unwanted movement and ensure they are
unlocked when moving to desired position.
STEP 3
Use screws (d) and washers (e) to x
the 360 degree swivel system to the
llable base (n).
Fix the lower pole (a) to the 360 degree
swivel system using screws (c) and
washers (e).
Fill the base with water.
STEP 4
Place the plastic cone (j) over the lower
pole and position over the 360 degree
swivel system so that the notch for the
foot pedal is located correctly and the
plastic cone sits straight.
STEP 5
Place the plastic cover (i) onto the
bottom of the umbrella pole.
o
n
j
a
c
d
e
e
b
n
f
i
o
n
j
a
c
d
e
e
b
n
f
i
o
n
j
a
c
d
e
e
b
n
f
i

STEP 6
Lower the umbrella frame and canopy (f)
onto the base (a) ensuring that the screw
holes match up.
Push the plastic cover (i) down until it
clicks into the plastic cone (j). Secure the
poles together using the screw with plastic
cap (h). a
h
1
1
1
1
2
2
2
2
g
i
f
a
h
1
1
1
1
2
2
2
2
g
i
f
a
h
1
1
1
1
2
2
2
2
g
i
f
STEP 7 - TO OPERATE
Undo the Velcro umbrella ties to free the
canopy. Pull the trigger on the easy glide
handle and li until it locks into the lowest
position.
STEP 8
Open the umbrella by inserting and
winding the rotating crank handle (g).
STEP 9
Adjust the angle of the canopy by pulling
the trigger and sliding the easy glide
handle up and down the post.
Lock into the desired position.
STEP 10
The umbrella can be rotated 360 degrees
by stepping on the foot pedal (1) and
rotating the umbrella pole (2) to the
preferred locking position.