Coopers of Stortford 9666 User manual

Freestanding 5x Magnifying LED Lamp 9666 Instructions
Please read carefully before use and retain for future reference.
PARTS
A. ower pole
B.
C. Flexible neck
D. amp head
E. Upper pole
F. Stem cable
G. Mains adapter
H. Collar
I. ock connector
J. ON/OFF switch
ASSEMBLY
1. Take the flexible neck(C) and feed the stem cable(F) through
2. Screw the upper pole(E) clockwise into the flexible pole(C).
3. Feed the stem cable(F) through the lower pole(A).
4. Screw the lower pole(A) clockwise into the upper pole(E).
5. Connect the two ends of the cable by press the lock
6. Turn and tighten the metal collar(H) onto the base(B).
7. Carefully feed the excess cable into the lower pole(A).
USE
• Hold reading material directly parallel to the magnifier
lens. If not positioned correctly, the reading material
may appear distorted.
• The EDs are specially formulated to simulate the
characteristics of natural sunlight. They are non-
replaceable and should give up to 50,000 hours of use.
• Turn off and unplug the light when not in use.
E
C
D
J
F
A
H
IB
G
K. DC plug
K
Take care not to pinch the cable.
Take care not to pinch the cable.
the upper pole(E).
connectors(I) into place.
Do not cut or shorten the cable.
8. Take out the screw and insert the lower pole(A) into
the metal collar(H).
9. Check direction of the lamp head and line up the screw hole
and use a screwdriver to tighten the screw.
10. Connect the DC plugs(K) on the external power cord.
11. Plug adapter into main outlet and turn on the lamp using
the ON/OFF switch(J).
Base
Upper pole
n

WARNING
• Ensure that your mains voltage corresponds to that stated on the unit.
• Use only the adaptor supplied.
• Never use the unit if any part is damaged.
• There are no user serviceable parts, if a fault develops, the unit must be
returned to the supplier for repair/replacement subject to guarantee conditions.
• Do not allow the unit to get wet.
• Do not allow the cable to lie on hot surfaces.
• Keep the magnifier away from direct sunlight when not in use.
• Do not look directly at the lit EDs.
• Route the power cable so that it will not get walked on or pulled (trip hazard).
• Do not allow children to play with this unit, it is not a toy.
• This unit should not be used by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction concerning use of
the unit by a person responsible for their safety.
• The unit is not intended to be operated by means of an external timer or
separate remote-control system.
CLEANING
• Always switch off and unplug from the mains and allow to cool before
cleaning.
• Wipe clean with a soft dry cloth.
• Do not use any chemical or abrasive cleaners.
TECHNICAL INFORMATION
ED Class:
Power supply: DC12V, 300mA - 1000mA
Power output: 2.5W
DISPOSAL
Dispose of all paper, cartons and plastic in accordance with your local recycling
regulations. At the end of the product’s lifespan please dispose of it at an
authorised household waste recycling centre.