6. DO NOT OPERATE ANY HEATER WITH A DAMAGED CORD OR AFTER THE HEATER MALFUNCTIONS,
HAS BEEN DROPPED OR DAMAGED IN ANY MANNER. RETURN HEATER TO AUTHORIZED SERVICE
FACILITY FOR EXAMINATION, ELECTRICAL OR MECHANICAL ADJUSTMENT, OR REPAIR.
7. THIS HEATER IS NOT INTENDED FOR USE IN BATHROOMS, LAUNDRY AREAS AND SIMILAR INDOOR
LOCATIONS. NEVER LOCATE HEATER WHERE IT MAY FALL INTO A BATHTUB OR OTHER WATER
CONTAINER. TO PROTECT AGAINST ELECTRICAL HAZARDS, DO NOT IMMERSE IN WATER OR OTHER
LIQUIDS.
8. DO NOT TOUCH THE CONTROL PANEL OR PLUG WITH A WET HAND.
9. DO NOT RUN CORD UNDER CARPETING. DO NOT COVER CORD WITH THROW RUGS, RUNNERS, OR
SIMILAR COVERINGS. ARRANGE CORD AWAY FROM TRAFFIC AREA AND WHERE IT WILL NOT BE
TRIPPED OVER.
10. DO NOT INSERT OR ALLOW FOREIGN OBJECTS TO ENTER ANY VENTILATION OR EXHAUST OPENING
AS THIS MAY CAUSE AN ELECTRIC SHOCK OR FIRE, OR DAMAGE THE HEATER.
11. TO PREVENT A POSSIBLE FIRE, DO NOT BLOCK THE AIR INTAKES OR EXHAUST IN ANY MANNER. DO
NOT USE ON SOFT SURFACES, LIKE A BED, WHERE OPENINGS MAY BECOME BLOCKED.
12. A HEATER HAS HOT AND ARCING OR SPARKING PARTS INSIDE. DO NOT USE IN AREAS WHERE
PETROL, PAINT, EXPLOSIVE AND/OR FLAMMABLE LIQUIDS ARE USED OR STORED. KEEP UNIT
AWAY FROM HEATED SURFACES AND OPEN FLAMES.
13. ALWAYS PLUG HEATERS DIRECTLY INTO A WALL SOCKET NEVER USE WITH AN EXTENSION CORD
OR RELOCATABLE POWER TAP(OUTLET/POWER STRIP).
14. TO AVOID FIRE OR SHOCK HAZARD, PLUG THE UNIT DIRECTLY INTO AN ELECTRICAL OUTLET.
15. TO DISCONNECT HEATER, TURN CONTROLS TO OFF, THEN REMOVE PLUG FROM OUTLET. PULL
FIRMLY ON THE PLUG, DO NOT UNPLUG BY PULLING ON THE CORD.
16. ALWAYS UNPLUG THE UNIT BEFORE MOVING OR CLEANING, OR WHENEVER THE HEATER IS NOT
IN USE.
17. USE ONLY FOR INTENDED HOUSEHOLD USE AS DESCRIBED IN THIS MANUAL. ANY OTHER USE NOT
RECOMMENDED BY THE MANUFACTURER MAY CAUSE FIRE, ELECTRIC SHOCK, OR INJURY TO
PERSONS. THE USE OF ATTACHMENTS NOT RECOMMENDED OR SOLD BY UNAUTHORIZED DEALERS
MAY CAUSE HAZARDS.
18. ALWAYS USE ON A DRY, LEVEL SURFACE.
19. DO NOT USE OUTDOORS.
20. WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT USE THIS UNIT WITH ANY
SOLID-STATE SPEED CONTROL DEVICE.
21. DO NOT ATTEMPT TO REPAIR OR ADJUST ANY ELECTRICAL OR MECHANICAL FUNCTIONS ON THIS
UNIT. THE INSIDE OF THE UNIT CONTAINS NO USER SERVICEABLE PARTS. QUALIFIED PERSONNEL
SHOULD PERFORM ALL SERVICING ONLY.
SAVE THESE INSTRUCTIONS
SAFETY FEATURES
Overheat Safety Feature
This heater is equipped with a overheat safety feature. When the heater’s internal components reach a
certain temperature that could cause overheating or possible fire, the heater will automatically shut off.
WARNING: It is normal for the power cord to feel warm to the touch; however, a loose fit between the
outlet and the plug may cause overheating of the plug. If this occurs, try inserting the plug into a different
outlet. Contact a qualified electrician to inspect the original outlet for damage.
