CSE-1500S 2 Rev. 07/02/03
OWNER/USER RESPONSIBILITY
The owner and/or user must have an understanding of
the manufacturer’s operating instructions and warnings
before using this underhoist stand. Personnel involved in
the use and operation of equipment shall be careful,
competent, trained, and qualified in the safe operation of
the equipment and its proper use when servicing motor
vehicles and their components. Warning information
should be emphasized and understood. If the operator is
not fluent in English, the manufacturer’s instructions and
warnings shall be read to and discussed with the operator
in the operator’s native language by the purchaser/owner,
making sure that the operator comprehends its contents.
Owner and/or user must study and maintain for future
reference the manufacturer’s instructions and pertinent
warning information. Owner and/or user is responsible
for keeping all warning labels and instruction manuals
legible and intact. Replacement labels and literature are
available from the manufacturer.
INSPECTION
Visual inspection should be made before each use of the
underhoist stand. Any stand which appears to be
damaged in any way, is found to be badly worn, or
operates abnormally must be removed from service. If the
stand is accidentally subjected to an abnormal load or
shock it must be inspected by a manufacturer’s
authorized repair facility immediately. It is recommended
that an annual inspection of the stand be made by a
manufacturer’s authorized repair facility and that any
defective parts, decals, or warning labels be replaced with
manufacturer’s specified parts. All repairs must be made
by a factory authorized service center. A list of authorized
repair facilities is available from the manufacturer.
ASSEMBLY INSTRUCTIONS
1. Attach Post Support (#4) to Base (#1.)
2. Insert Post (#2) into the Post Support (#4). Secure by
aligning the holes of both the Post (#2) and Post
Support (#4) and inserting (1) 5/8" x 2-1/2" Clevis Pin
(#5), (2) 11/16" Washers (#6), and (1) Cotter Pin (#7).
See exploded diagram for proper placement.
3. Attach Pedal (#10) to the Post Support (#4) and secure
with (1) 1/2" x 1-1/2" Clevis Pin (#8), (2) 1/2" Washers
(#9) and (1) Cotter Pin (#7). See exploded diagram for
proper placement.
4. Set Saddle (#11) on top of Post (#2) and screw Hex Bolt
(#12) through saddle to secure on post.
OPERATING INSTRUCTIONS
To Raise:
Turn adjusting handle clockwise until saddle contacts
load. Continue turning handle to raise load to
required height. For extra height, press down on
foot pedal (#10).
To Lower:
Turn adjusting handle counterclockwise.
Capacity . . . . . . . . . . . . . . . . . . . . . 1500 Lbs.
Low Height . . . . . . . . . . . . . . . . . . . . . . . 53"
Raised Height . . . . . . . . . . . . . . . . . . . . . 80"
Base (diameter) . . . . . . . . . . . . . . . . . . . . 12"
Shipping Weight . . . . . . . . . . . . . . . . 29 Lbs.
CSE-1500S SPECIFICATIONS
