Cosmo CFRWN User manual

SAFETY
INFORMATION
INTRODUCTION
POWER UP
DEVICES THAT CAN
BE CONNECTED
BOX CONTENT
Use in accordance with the regulations.
Indoor use only. Keep your device
completely dry. Disconnect your device
before cleaning it with a dry cloth. This
accessory must be fitted by a competent
person, and installation must comply with
the guidance, standards and regulations
applicable to the city, country or state
where the product is installed. Failure to
comply with the relevant standards could
lead to prosecution.
If your Smart Home system has more than
32 battery-powered devices, alongside
the ZigBee Coordinator of the CFKL8
Wiring Centre you must add a CFRWN
ZigBee repeater.
You must also add a CFRWN repeater
if the battery-powered devices in your
Smart Home system are too far away
from the mains-powered devices.
Note: CFRWN Repeater must be
connected to the network FIRST!
PRODUCT
COMPLIANCE
This product complies with the essential
requirements and other relevant
provisions of Directives: EMC 2014/30/EU,
RED 2014/53/EU and RoHS 2011/65/EU.
2405-2480MHz; <14dBm
CFRWN
1 x EU Plug Adapter
Quick Guide
Plug
Repeater
Plug the repeater into the adaptor.
Plug the repeater into the power outlet.
ZigBee Repeater
Model: CFRWN
Quick Guide
COSMO GmbH
Brandstücken 31
22549 Hamburg
[e-mail]
www.cosmo-info.de
March 2020
V003
1
2
3
+
CFRWN
CRTDW CFTDW
CFRWNCFKL8

INSTALLATION -
OFFLINE
INSTALLATION -
ONLINE FACTORY RESET
111
2
2
3
4
4
Open the ZigBee network
OR
5 sec
5 sec
The repeater button flashes red. Press
and release the repeater button.
The LED goes solid red to show it is
connected to the network.
2
3
Close the ZigBee network
OR
5 sec
5 sec
Scan for equipment
SALUS
Smart Home
Name this equipment
CFRWN
Connect equipment
Finish
15 sec
Press the repeater button for 15 seconds
to delete it from the network.
The button colour changes to amber
to indicate deletion.
At this point, you cannot cancel the
procedure.
Note:
After you have deleted the repeater from
the ZigBee network, it will need to be
re-installed.
Also, if you delete the repeater, all the
thermostats connected to the repeater
will lose their connection to the network.