Costco 1900686 Quickspecs

1
ITM. / ART. 274041ITM. / ART. 1900686 ITM. / ART. 41134
FOR OUTDOOR HOME USE ONLY
WARNINGS AND CAUTIONS-RISK OF SHOCK
Clamp
PACKAGE CONTENTS
PART # PART DESCRIPTION QUANTITY
RB-1 1
PART # PART DESCRIPTION QUANTITY
RB-6
RB-5
1
6
RB-4 2
Shim
RB-9 1
Tower
RB-8 1 RB-3 1 Pump
Cap
Pump Connector
RB-7RB-2 11
Base Transformer
Screwdriver
ASSEMBLY CARE & USE INTRUCTIONS
IMPORTANT, RETAIN FOR FUTURE REFERENCE.READ CAREFULLY
Before returning to Costco, call our customer service department at
1-888-868-1808 ext.400, 8:30 a.m. - 5:00 p.m., PST, Monday-Friday,
or email us at [email protected]. (English & Spanish available)
Questions, problems, missing parts?
REMINDER
SAVE THESE
INSTRUCTIONS
While installing, keep children and pets out of reach. Remember to make sure the plug is dry and clean before inserting into the
ground fault circuit interupter (GFCI) outlet.
To reduce the risk of electric shock, use only on portable self-contained fountains no larger than 5 feet
in any dimension.
The National Electric Code requires that a ground fault interrupter circuit (GFCI) be installed in every branch
circuit supplying the fountain or pond equipment.
Do not immerse the plug in water. DO NOT REACH INTO THE WATER TO REMOVE THE PLUG. TURN OFF
CIRCUIT FIRST.
A "drip loop" in the cords should be used. A "drip loop" is a loop in the cord below the level of the receptacle or
plug that prevents water from traveling along the cord.
WARNING: FOR YOUR PROTECTION,ALWAYS UNPLUG THE UNIT FROM ITS POWER SOURCE BEFORE INSTALL-
ING OR SERVICING.
DO NOT REACH, REMOVE, OR DISASSEMBLE THE PUMP BEFORE YOU DISCONNECT THE POWER.
Please lay out all parts prior to assembly or installation. Read instructions prior to assembly or installation.

2
ASSEMBLY INSTRUCTIONS
Remove cap and run plug from pump through tube in base
Replace cap, and screw hose connector to pump
1
2
①
②
③
This pump has been evaluated for use with fresh water only.
Use a proper power source as indicated on the pump label.
Keep the cord away from high temperatures or other heat sources.
Do not pump heated liquids.
Avoid heavily chlorinated water and water with high pH levels.
Do not lift the pump by its power cord.
CAUTION
a. Remove cap from tube and set aside
for step 2.
a. Replace cap from step 1 on top of tube in base.
b. Run cable from pump through tube and pull through notch
in base until tag showing STOP HERE.
b.Screw hose connector onto pump
body(clockwise) and hand tighten.
stop here
Arrêtez ici
Deténgase aquí
stop here
Arrêtez ici
Deténgase aquí

3
Remove cap from transformer,
plug in pins from pump to connection on transformer
3
The attachment of tubing to pump
4
Fill with water
5
① ②
a. Remove protective cap from
connection on transformer.
b. Insert plug from pump to socket on transformer and tighten cap on
pump cable until it is firmly seated to transformer.
a. Carefully lay tower down to attach tubing to pump. b. Slide tubing with clamp on to the pump
connector and tighten with screwdriver tool.
a.Fill base with water to label showing
WATER LINE on tube in base.
Time between adding water can vary
due to humidity and temperature in
your region.
Due to evaporation, clean water must
be added periodically.
Water Line Niveau de l'eau Línea de agua

4
CARE AND MAINTENANCE
Regular cleaning of the pump may be necessary depending upon the environment in which it is operated. Clean
the pump and the impeller assembly when it is visibly soiled or when a drop in performance is detected.
Before cleaning, always disconnect the pump from the power source.
Disassemble the pump cover and remove the impeller cover to expose the impeller assembly.
Remove the impeller assembly by gently pulling on the impeller blades. Use a soft cloth or brush to clean the
impeller assembly and the inside of the impeller housing.
Remove all parts from the pump and clean in warm, soapy water.
Lift base to edge, place pump, then straighten tower
6
Use shims to level the fountain7
①②
a. Two people- Carefully lift tower to top of base and
hold at an angle.
c. After pump is placed in base, straighten tower into position.
a. If surface under base is uneven or water is not flowing evenly from top of fountain, use shims included
to level the fountain. Insert shim on opposite side where water is not flowing.① Once positioned, break
off excess shim at notch.②
b. While at angle, place pump in water, on
floor of base.

5
TROUBLESHOOTING
RELACEMENT PARTS LIST
If the pump fails to operate:
For questions or replacement parts, call our Hotline at 1-888-868-1808 ext 400 8:30 a.m.-5:00 p.m., PST,
Monday-Friday or email us at [email protected].
Check the circuit breaker and try another outlet to ensure the pump is getting electrical power.
Check the pump outlet and tubing for kinks or obstructions. Algae build up can be flushed out with a
Garden hose.
Check the bottom of pump to confirm that the intake screen it is not clogged with debris.
Remove the front cover, and impeller cover to expose the impeller. Turn the impeller to ensure that it is not
broken or jammed.
If the performance of the pump is not satisfactory or the pump does not flow evenly:
Check to make sure the impeller assembly, water sensor, and the front cover are clean.
Adjust flow control knob as needed.
Part Description
1/2 in. ID tubing adapter
AA
B
B
C
C
D
D
E
FF
G
G
H
H
E
E
I
Flow control knob
Front cover
Impeller cover
Shaft support
Back cover
Water sensor
I
Shaft
Impeller assembly
DO NOT ALLOW WATER TO FREEZE IN FOUNTAIN OR PUMP
WINTERIZATION AND STORAGE
If fountain is used in areas with harsh winters where temperatures can drop below freezing even for short
periods of time, it is recommended that all water be removed from the fountain during the cold months.
Also remove the pump by disconnecting from the hose. Clean the pump with plain water and dry it
thorougly before storing the pump in a temperature controlled atmosphere (above freezing).
If pump is removed, clean it with fresh water and dry it thoroughly before storing. It is strongly
recommended to clean the impeller assembly and chamber before storing.
We recommend that you store the fountain during the winter in a climate controlled
garage/shed or cover completly with an outdoor tarp.

6
MADE IN CHINA/FABRIQUÉ EN CHINE/HECHO EN CHINA
When using electrical products, basic precautions should always be practiced including the following:
READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
Read and follow all instructions that are on the product or provided with the product.
Do not use an extension cord.
Installation work and electrical wiring must be done by qualified person(s) in accordance with all
applicable codes and standards, including fire-rated construction.
Do not install or use within 10 feet of a pool.
Do not use in a bathroom.
WARNING: Risk of Electric Shock. When used outdoors, install only to a covered Class A GFCI protected
receptacle that is weatherproof with the power unit connected to the receptacle. If one is not provided,
contact a qualified electrician for proper installation. Ensure that the power unit and cord do not
interfere with completely closing the receptacle cover.
WARNING: Risk of Fire. Installation involves special wiring methods to run wiring through a building structure.
Consult a qualified electrician.
Reference the National Electrical Code, ANSI/NFPA 70, specifically for the installation of wiring and
clearances from power and lighting conductors.
Distributed by:
Imported by / Importé par :
Importado por:
Imported by:
Costco Wholesale Corporation
Costco Wholesale Canada Ltd.*
Importadora Primex S.A. de C.V.
Costco Wholesale Australia Pty Ltd
P.O. Box 34535
415 W. Hunt Club Road
Blvd. Magnocentro No.4
17-21 Parramatta Road
Seattle, WA 98124-1535
Ottawa, Ontario
San Fernando La Herradura
Lidcombe NSW 2141
USA
K2E 1C5, Canada
Huixquilucan, Estado de México
Australia
1-800-774-2678
1-800-463-3783
C.P. 52765
www.costco.com.au
www.costco.com
www.costco.ca
RFC: IPR-930907-S70
* faisant affaire au Québec sous
(55)-5246-5500
le nom les Entrepôts Costco
www.costco.com.mx
Imported by:
Importado por:
Distributed by:
Distribué par :
Costco Wholesale UK Ltd /
Costco Wholesale Spain S.L.U.
Costco Wholesale Iceland ehf.
Costco France
Costco Online UK Ltd
Polígono Empresarial Los Gavilanes
Kauptún 3-7, 210 Gardabaer
1 avenue de Bréhat
Hartspring Lane
C/ Agustín de Betancourt, 17
Iceland
91140 Villebon-sur-Yvette
Watford, Herts
28906 Getafe (Madrid) España
www.costco.is
France
WD25 8JS
NIF: B86509460
01 80 45 01 10
United Kingdom
900 111 155
www.costco.fr
01923 213113
www.costco.es
www.costco.co.uk
Imported and Distributed by:
Imported by / Manufactured for:
Costco Wholesale Korea, Ltd.
Costco President Taiwan, Inc.
40, Iljik-ro
No. 656 Chung-Hwa 5th Road
Gwangmyeong-si
Kaohsiung, Taiwan
Gyeonggi-do, 14347, Korea
Company Tax ID: 96972798
1899-9900
449-9909 or 02-449-9909 (if cellphone)
www.costco.co.kr
www.costco.com.tw
Imported and Distributed by:
Imported by / Manufactured for:
Costco Wholesale Korea, Ltd.
Costco President Taiwan, Inc.
40, Iljik-ro
No. 656 Chung-Hwa 5th Road
Gwangmyeong-si
Kaohsiung, Taiwan
Gyeonggi-do, 14347, Korea
Company Tax ID: 96972798
1899-9900
449-9909 or 02-449-9909 (if cellphone)
www.costco.co.kr
www.costco.com.tw
REMINDER
CALL 1-888-868-1808 ext.400 or email us at [email protected]
BEFORE RETURNING TO STORE.
This manual contains important safety and operating instructions for power units.
IMPORTANT SAFETY INSTRUCTIONS  SAVE THESE INSTRUCTIONS
LIMITED WARRANTYPUMPS
Our fountain pumps come with a 2 year limited warranty against manufacturing defects.
The warranty does not cover damage as a result of electrical supply problems, abuse, or misuse.
Any damages due to improper installation are not covered by this warranty.
If it becomes necessary to return a pump or fountain component for service,
CALL 1-888-868-1808 ext. 400 for shipping instructions.