COTSWOLD WASH STATION Service manual

COTSWOLD
WASH STATION
Automatic Washing Facility
INSTALLATION & INSTRUCTION
MANUAL
Cotswold Dairy Equipment Co Ltd
Avenue 3 Station Lane
Witney
Oxford
OX8 6BP
UK
Tel & Fax [phone]
e-mail [email protected]
www.cotswold-dairy.co.uk
WASHSTATION2017.CDR
One Pressure
Reducing Valve to a
sequential row of
heaters
One Pressure
Reducing Valve to
a single heater
High water pressure (greater than 60psi) can cause the
safety valve inside the heater to expel a tiny ball and then
release a tiny stream of water.
If you have high water pressure, or are in any doubt about
your pressure, fit a pressure reducing valve. This can
protect a single heater, or a row of heaters, as shown
PRESSURE REDUCING VALVE

Description
The Cotswold Wash Station is a stainless steel fully automatic wash station with
features including finger tip soap dispensing and hands-free on-off of water sprayer.
* Hygienic Hands-Free operation
* Soap Dispenser with easy change cartridge system
* Energy Efficient - shuts off after 30 seconds
* Water -efficient, uses fine spray
*Safe pre-set temperature
* Easy clean, easy maintenance
* Suitable for any industry
INSTALLATION
DO NOT install outside, or in any position where the entire
unit could be subjected to water spray
The Wash Station can be fitted to any vertical surface with an adjacent cold water
supply and convenient 13 amp 230 volt supply. Set the unit at a height suitable for
intended users, remembering that if children will be
using it, it may need to be set lower than usual. Ensure
that there is no possibility of splashes or wet hands
coming into contact with adjacent electrical outlets.
MOUNTING. The Wash Station requires a wall area
520mm wide by 1000mm height. Drill 4 number 8 holes
as drawing, fit wall plugs supplied and screw in screws
supplied, leaving approx ¼” (6mm) under each head.
The unit can then be hooked onto the screws and the
screws tightened (on irregular surfaces, do not
overtighten or distort the unit)
WIRING. We provide a length of 13amp twin-and-earth
flexible wire, which emerges from the left side of the
unit. It is easy to transfer the outlet to the opposite side,
transferring the blocking grommet to the spare hole. If
the wire is not long enough, it is preferable to discard this wire and replace it with
another of the correct length for your installation (conductors min 2.5mm²).
WIRING: THIS UNIT MUST BE EARTHED
continued......
Cotswold
WASH STATION
PAGE 2
12
3
4
5 6
SETTING UP THE WASH STATION
Use these instructions in conjunction with the Hyco “Hand Wash”
operating instructions included with this manual.
Set the temperature of the spray using the front flow control (Hyco Manual page 6).
The faster the flow, the lower will be the spray temperature.
The water heater is of the instantaneous type, and the temperature of the spray is
dependent on the temperature of the incoming water supply, which varyies throughout the
year. This means that - to achieve a given spray temperature - the flow will be lower in
winter than in summer.
.
CHANGING THE SOAP CARTRIDGE
WASHSTATION2017.CDR
PAGE 3
WATER SUPPLY Connect a cold water supply to the unit using a 15mm compression
fitting or similar connection. The mains water pressure should be between 0.69 bar (10
psi/69kPa) and 4.0 bar (66 psi/460kPa). Ideally, fit an isolating valve on the inlet side to
facilitate servicing without turning off the supply to adjacent units (see back page).
WASTE DRAINAGE The Wash Station comes with connections for standard 1¼”BSP
waste pipe. In some agricultural and similar situations, drainage straight into a portable
receptacle or directly onto the floor may be acceptable.
SOAP The unit is supplied with a soap cartridge already fitted into the dispenser.
Replacement cartridges are available from Cotswold or your Cotswold Dealer either singly
500mm
578mm
The soap dispenser is
supplied fitted with a 1litre
cartridge of soap.
To open the soap
dispenser, use the
supplied key in the hole
either in the top-right or
top-left of the unit. The
unit will then swing
downward to open.
(DO NOT
LOSE
YOUR
KEY)
LOCKS
USING THE COTSWOLD WASH STATION
To use the Wash Station, dispense soap by cupping your fingers under the soap dispenser
whilst pressing with the thumb or the other hand, then pass a hand in front of the green
“detector”. A warm spray will begin which will stop either when you next pass a hand in front of
the detector, or after approximately 30 seconds.