Cottonwood Universal Click Chair User manual

.Fasten each rubber tape on the cover on to each plastic
pin on the PreClc frame as shown
Pre Clc Chair Cover (2pcs.)
Assmbles Universal Click Chair
(2pcs).
(4pcs).
(4pcs).
MajClc CHAIR COVER
. Begin installation of the MajClc Chair cover only after have complete
assembly of the Universal Click Bed
. All item require for installation can be found in
. With Universal Click Sofa in sitting position place the protective cloth
strip you removed from the Velcro located inside the perimeter of the
skirt and place it behind the flaps attaching the Velcro to the strip as
shown Diagram 3
. Attach the MajClc Perimeter Skirt on around the edge of the assembled
sofabed as shown in diagram 1 and 2
Chair Bed (2pcs)

MajClc CHAIR COVER
(4pcs).
. Position the assembled Universal Click chair Bed flat as shown in
Diagram 8
. Spread the MajClc pillow top cover chair bed cover over the
Universal Click chair bed
. Connect the MajClc pillow top cover to the Universal Click chair
bed using the zipper, starting in the side of the unit as shown

(6 pcs)
(6 pcs)
UNIVERSAL CLICK CHAIR
CHAIR ASSEMBLY
1. Attach front flare leg (G) using
M8x30 Bolt (B) .When attaching to base
turn each bolt untill it cataches, then
tighten by alternating so bolts go down
evenly.Do not tighten one at a time.
2. Attach back pipe leg (H) by turning
directly into position as shown.
3. The hardware B, D, I item not using
if you assembly UNIVERSAL CLICK
CHAIR
1
2
Flat Washer
(6 pcs)
Pillow Insert
(2pcs),w Hardware
Pillow Insert
(2pcs),w Hardware
box
A
G

UNIVERSAL CLICK CHAIR
CHAIR ASSEMBLY
1. The Chair bed has three recline position show in Diagram 2 Bed (A), Recline (B), Sofa (C).
2. To convert the chair bed to its desired position stand in the middle at the back, push the back section forward
slowly to release the mechanism. Gently guide the back down to the bed position
Chair Position