Creative Play PB114 User manual

WEATHER STATION
Installation Instructions
REF: PB114 - WEATHER STATION
pg 1 of 6

pg 2 of 6 REF: PB114 - WEATHER STATION
PARTS required
x10(FM80 ‘Brass screws’)
x4 (N3 - TORKTAINER)
x4 (4B - TORKTAINER )
x1 PRE-ASSEMBLED PLAYTEC BOARD x1 PRE-ASSEMBLED END CAP &
ANEMOMTER
x2 PLAYTEC BRACKETS FOR RAINFALL
MEASURE & PEN POT x2 PLAYTEC BRACKET PIECES
x1 LOOSE END CAP
x1 RAINFALL MEASURE
x1 24INCH WINDSOCK
x1 PEN POT
QTY x 2
(90mm x 90mm)
PB114a

pg 3 of 6 REF: PB114 - WEATHER STATION
TOOLS required

pg 4 of 6 REF: PB114 - WEATHER STATION
Foundation Details
600mm
400mm X 400mm
150mm
CONCRETE SOIL

pg 5 of 6 REF: PB114 - WEATHER STATION
Attach End Caps to timber
Attach Playtec to timber uprights
Concrete timbers into ground as specified on PG 4
1
2
BEFORE TIMBER IS PLACED INTO
GROUND:
FIX END CAP TO TIMBER USING 2X FM80
BRASS SCREWS.
USE THE MIDDLE HOLE AS A GUIDE -
DRILL DOWN 100MM
(using 10mm drill bit)
WINDSOCK ROD TO BE GLUED INTO THE
TIMBER
(Glue to be placed in drilled 100mm hole
- not on end cap.)
BEFORE TIMBER IS PLACED
INTO GROUND:
FIX END CAP (WITH ATTACHED
ANEMOMETER) TO TIMBER
USING 2 X FM80 BRASS
SCREWS
Attach using 6x FM80
BRASS SCREWS
Installation Instructions
100mm
465mm
TOP EDGE OF BOARD
INLINE WITH TOP OF
TIMBERS

pg 6 of 6 REF: PB114 - WEATHER STATION
Attach Rainfall Measure & Pen Pot brackets to board
Put Rainfall & Pen Pot into place
3
4
Installation Instructions
PLACE BRACKETS THROUGH
PLAYTEC BOARDS SO THAT THE
SLIT IN EACH IS VISIBLE FROM
BEHIND THE BOARD
NOTE:
EACH BRACKET HAS A DIFFERENT INTERNAL HOLE DIMENSION.
THE RAINFALL MEASURE IS TO BE POSITIONED ON THE LEFT (INTERNAL HOLE DIMENSION - 58MM) & THE PEN POT
ON THE RIGHT (INTERNAL HOLE DIMENSION - 65MM)
ONCE BRACKETS ARE IN PLACE -
SLOT IN PLAYTEC PIECES AND TORKTAINER
INTO PLACE USING 4 X 4B-N3’S
LEFT - RAINFALL MEASURE
RIGHT - PEN POT