Creative Playthings Bridgehampton Premium Pack 2 User manual

BRIDGEHAMPTON PREMIUM PACK 2
BRID9WPP2-100 Rev A (12-19)
© Copyright 2018, Creative Playthings
CHILDHOOD STARTS HERE
BRID9WPP2
B P P 
The components of this gym can be combined with others to create different play sets.
This is the best order of assembly to create this specic set.
Read this sheet and all instructions included with the different parts before assembly.
See the Instructions and Owner's Manual included in carton 63006-445
for important safety information.
Dimensions of assembled package:
37' 3" wide x 21' 3" deep x 12' 9" tall
Cartons for this Play Set:
1 63006-421 Williamsburg Box 1 (Hardware)
1 63006-422 Williamsburg Box 2
1 63006-423 Williamsburg Box 3
1 63006-445 Williamsburg Roof (Hdwre & Instr)
2 SH946-102 Access Ladder, 5ft
1 63007-421 Lexington Gym 1 (Hardware)
1 63007-422 Lexington Gym 2
1 63007-423 Lexington Gym 3
1 63007-445 Lexington Roof (Hdwre & Instr)
1 63058-202 4 Position Swing Beam
1 63060-222 9ft Swing Beam Legs (Hdwre & Instr)
1 50546-777 3 Swings, 1 Trapeze
1 63008-221 Skybox 1 (Hdwre & Instr)
1 63008-222 Skybox 2
1 SJ926-810 Skybox Wood Roof (Hdwre & Instr)
1 15166-400 10 ft. Super Wave Slide
1 AH201-102Q Rock Climbing Wall (Hdwre & Instr)
1 63079-102 Monkey Bars (Hdwre & Instr)
1 63081-102 Ice Cream Stand (Hdwre & Instr)
1 SD204-102Q Lex. Picnic Table (Hdwre & Instr)
1 SH922-800Q Ramp (Hdwre & Instr)
1 63073-101 Clubhouse Window Pk (Hdwre & Instr)
1 63090-222 Chain Climber Frame
1 63089-606 Chain Cargo Net
1 15140-400 14ft Rocket Slide & Foot
1 50398-700 Skybox Slide Kit (Hdwre & Instr)
1 8400-202 Spiral Slide, Green (Hardware)
1 63033-102 Spiral Mount (Hdwre & Instr)
1 SC908-800Q Wmsburg Play Floor (Hdwre & Instr)
1 SC910-800Q Lexington Play Floor (Hdwre & Instr)
1 SC904-800Q Skybox Play Floor (Hdwre & Instr)
1 AP970-104 Bubble Panel (Hdwre & Instr)
2 AG942-400 Acc. Ladder Handles (Hdwre & Instr)
2 AG943-400 Slide Handle (Hdwre & Instr)
3 SM964-402 Gable Fans (Hdwre & Instr)
3 SM963-402 Dormer (Hdwre & Instr)
1 SJ951-102 Bridge (Hdwre & Instr)
1 40456-402 End Window Panel
1 40457-402 Side Window Panel
1 40458-402 Side Door Panel (Hdwre & Instr)
• Start by assembling the Williamsburg tower. Instructions and hard-
ware are in the cartons noted at left. Notice the gym is rotated 90°
from the position shown in the instructions
• Wait to install the Access Ladder, Slide, and Wall Slats until after the
rest of the play set is complete.
• Wmsbg step 2. Do not install the Sandbox End on the end adjacent
to the Skybox. It will be replaced when installing the play oors.
• Wmsbg step 7. Do not install the safety rail. It will be used on the Play
Walls.
• Wmsbg step 14. Do not install the End Wall Support adjacent to the
Skybox. It will not be needed.
• Wmsbg step 15. No Swing Mount is needed.
• Once the roof, roof supports, and ridge cap are installed, proceed
with the Skybox tower.
• Skybox step 2. Omit the sandbox end under the gym. The oor transi-
tion from the Skybox Play Floor will be used instead.
• Skybox step 11. Use the front posts from The Skybox Roof (SJ926-
810) in place of the post extensions.

© Copyright 2018, Creative Playthings
BRIDGEHAMPTON PREMIUM PACK 2
BRID9WPP2-100 Rev A (12-19) Page 2
• Skybox Step 17. Wait to install the wall slats on the back
and side where the bubble panel and slides will mount,
and the side where the Swoosh Slide will mount until after
installing the bubble and slide.
• Skybox Step 21 & 22. Install the slats in reverse orientation
so the opening is on the opposite side. Install the ladder
aligned with the opening.
• Ignore the special instructions regarding mounting with
play oors in the Skybox instructions. Use the method
found on the bottom of page three of the skybox play oor
instructions.
• Once the basic Williamsburg-Skybox tower is assembled
assemble the Lexington tower about 92" away from the
Williamsburg. Please note: The swing beam extends from
the end of the tower, 90° from the position shown in the
beam assembly instructions.
• Wait to install the Access Ladder, Slide, and Wall Slats until
after the whole play set is complete.
• Lex step 7. Do not install the safety rail. It will be used for
the picnic table.
• Lex step 8. Before securing the angle braces, move the
tower into place 92" from the other tower. Use the bridge
rails from SJ951-102 to assure the alignment is exact.
Continue assembly making sure the posts are plumb and
the towers are level.
• Lex step 15. No swing mount is needed.
• Lex step 25. Before installing the roof, nd the post where
the swing beam will mount. Drill 7/16" diameter holes
through the post at 3", 7-1/4" and 15-1/2" below the top of
the post as shown at above right. The beam will be mount-
ed to the front of the post using these holes. Insert one
5/16" weld nut into the top hole on the inside face of the
post. Be sure the threads on the weld
nut are clear, it will be captured by the
roof support. Install the roof.
• After installing the roof, install the
bridge between the towers using the
instructions from SJ951-102.
• Install the swing beam. Instructions
and hardware are in the 9' Swing Beam
Leg Carton (63060-222).
• Install the Monkey Bars (63079-102) to
the front center of the Bridge.
• Using a ladder, install three Dormers
(SM963-402) in the positions shown on
the front page. Ladder access may be
obstructed by later installations.
• Install 3 pairs of Gable Fans (SM964-
402) at each end of each roof.
• Install the Wmsburg Play Floor (SC908-
800Q) and Skybox Play Floor (SC904-800Q) using the
method shown on page 3 of the Skybox Play Floor Manual.
• Install the Lexington Play Floor (SC910-800Q).
• Install the Lexington Picnic Table (SD204-102Q).
• Mount the Window and Door Panels (40456-402, 40457-
402, & 40458-402) in the Williamsburg tower as shown
above.
• Mount the Rock Climbing Wall (AH201-102Q) in the posi-
tion shown.
• Mount the Cargo Climber (63090-222) to the center of the
back of the Lexington tower.
• Mount the Super Wave Slide (15166-400), Access Ladder
(SH946-102) and Ramp (SH922-800Q) across the front of
15 1/2"
7 1/4"
3"
0"

BRIDGEHAMPTON PREMIUM PACK 2
BRID9WPP2-100 Rev A (12-19)
© Copyright 2018, Creative Playthings
the Lexington tower.
• Secure the Access Ladder (SH946-102) to the back of the
Williamsburg tower in the position shown above using the
method shown in step 17 of the Wmsburg instructions.
• Fasten two Access Ladder Handles (AG942-400) to each
Access Ladder.
• Assemble the Spiral Slide and secure it to the back of the
Skybox using the skybox mount (63033-102).
• Install the Bubble Panel (AP970-104).
• Install the Rocket Slide (15140-400) using the Skybox
Slide kit (50398-700).
• Mount a Slide Handle (AG943-400) above the Super Wave
Slide and Rocket Slide.
• Mount the Ice Cream Stand (63081-102) to the end of the
Skybox.
• Install the wall slats in the positions shown above and on
the rst page, using the methods from the Williamsburg
Instructions. Gaps must be narrower than 3-1/2" or wider
than 9" to prevent potential head entrapment.
• Mount the hand grips to the entrance wall slats.
• Install the Shutters and Flower Box from the Clubhouse
Window Pack (63073-101) to the window panel below the
Bridge.
• Double-check all fasteners are secure and all recessed
hardware is covered by hole caps.
• Hang the swings.