Creative Playthings Manchester Premium Pack 5 User manual

MANCHESTER PREMIUM PACK 5
MANC9WPP5-100 Rev A (05-18)
© Copyright 2018, Creative Playthings
CHILDHOOD STARTS HERE
MANC9WPP5
M P P 
• Assemble the Manchester tower as shown in the instructions in Man-
chester Box 1 (63069-601).
• Manchester step 39. Do not install front wall slats.
• Install the Dormer (SM963-402) before the swing beam, slide, or fun
deck for better ladder access.
• Tighten all connections on the Manchester then install the Fun Deck
using the instructions in 63070-301.
• Fun deck step 16. Do not install the end wall support included with
the fun deck. Use the end replacement included with the fun deck
spiral mount (63056-101). Installation is described in step 3 of the
spiral mount instructions.
• Fun deck step 22. Wait to install the narrow deck board on the side
where the spiral slide will mount.
• Fun deck step 23. Wait to install the wall slats on the side where the
spiral slide will mount. Set it in place but do not secure it.
• Install the Spiral Slide using the instructions included in 63056-101.
• Spiral mount step 7. Before installing the side supports, secure the
narrow deck board omitted in step 22 of the fun deck assembly. If
the deck board blocks a hole drilled in spiral step 1, insert 5/16" weld
nuts rst.
The components of this gym can be combined with others to create different play sets. This is the best
order of assembly to create this specic set.
Read this sheet and all instructions included with the different parts before assembly.
See the Instructions and Owner's Manual included in carton 63069-601 for important safety information.
Dimensions of assembled package:
16' 4" wide x 27' 0" deep x 12' 9" tall
Cartons for this Play Set:
1 63069-601 Manchester Box 1 (Instr & Hdwre)
1 63069-602 Manchester Box 2
1 63069-603 Manchester Box 3
1 63069-604 Manchester Box 4
1 63069-605 Manchester Box 5
1 63069-606 Manchester Box 6 (Hardware)
1 63069-707 Manchester Box 7
1 15168-400 Rocket Slide 12ft.
1 63058-202 4 Position Swing Beam
1 63076-303 9ft Beam Legs (Instr & Hdwre)
1 50546-777 3 Swings, 1 Trapeze
1 63070-301 Manch. Fun Deck 1 (Instr & Hdwre)
1 63070-302 Manchester Fun Deck 2
1 63053-404 Manchester Fun Deck 3
1 SM963-402 Dormer (Instr & Hdwre)
1 SM964-402 Gable Fans (Instr & Hdwre)
1 8400-202 Spiral Slide (Hardware)
1 63056-101 Fun Deck Spiral Mount (Instr & Hdwre)
1 AG943-400 Slide Handle (Instr & Hdwre)
1 AG942-400 Access Handles (Instr & Hdwre)

© Copyright 2018, Creative Playthings
MANCHESTER PREMIUM PACK 5
MANC9WPP5-100 Rev A (05-18) Page 2
• Spiral mount step 9. Before installing the slide entrance,
install the walls slats omitted in step 23 of the fun deck as-
sembly. Make sure all gaps are less than 3-1/2" to prevent
a possible head entrapment.
• Complete installation of the Spiral Slide.
• Install the swing beam using instructions from 63076-303
and step 46 in the Manchester manual. For proper t within
the play zone found in the Creative Playthings play zone
book, install the swing mount to the corner post by the rung
ladder.
• Install the Rocket Slide as shown in the step 31 of the fun
deck manual using the method shown in the Manchester
instructions.
• Install the Gable Fans (SM964-402).
• Install the Access Handles (AG942-400) on both sides of
the steps.
• Mount the Slide Handle (AG943-400) above the slide.
• Double-check all fasteners are secure and all recessed
hardware is covered by hole caps.