Creda C60AHBG User manual

1
USER
MANUAL
60CM DECORATIVE COOKER
HOOD
V 1.0
MODEL/S
C60AHBG

2
USER
MANUAL
You’ll soon be enjoying your new Creda
Cooker Hood!
It all begins here, with your instructions. Don’t worry, there’s nothing too technical
coming up. Just simple, step-by-step guidance to get you up and running quickly. Sound
good? Then let’s get started.
Help and Guidance
We’re here to help you get the most from your appliance.
Should you require any guidance, a simple solution can often be found online at:
www.creda.co.uk
If you still require further assistance, call one of our experts on 01759 487836.
If you require any technical guidance or find that your product is not operating as intended, a simple solution can
often be found in the Troubleshooting section of these instructions, or online at www.creda.co.uk If you still require
further assistance, call one of our experts on 01759 487836.

3
USER
MANUAL
Contents
PAGE
4
5
6
7
8
11
12
14
15
—
Safety instructions
General View
Accessories
Installation
Mounting Instructions
Control Panel
Maintenance and cleaning
Troubleshooting
Help and Assistance

4
USER
MANUAL
SAFETY INSTRUCTIONS
•IMPORTANT SAFETY INSTRUCTIONS READ CAREFULLY AND KEEP FOR
FUTURE REFERENCE
•It is recommended that the product be installed by authorized persons. Installation by unauthorized persons
could lead to poor operation performance, damage to the product, and accidents. The product will not be
covered by the warranty.
•Avoid connecting a chimney or air duct used to exhaust smoke from appliances that use gas from an electric
cooker hood or other fuels (stove, boiler, thermosiphon, etc.). This warning does not apply to uses without flue.
•Comply with the regulations of the authorities on the discharge of outlet air. (not applicable for devices that
discharge air back into the room).
•When the cooker hood is placed on a gas burning device, the distance between the hob and the hood should
be at least 65 cm. If a larger distance is specified in the installation instructions of the gas burning hobs, this
value should be taken into account.
•While the hood is running, ensure fresh air can enter the environment; especially when used at the same time
with gas baking ovens and solid and gas-fired appliances.
•For your safety, use ”Max 6.A” fuses in the hood installation.
•Do not leave boiling oil on the stove. Pots that contain boiling oil may catch fire by itself.
•Do not operate the hood without using cook wares. High heat may cause some parts of your product to deform
and cause fire.
•The packages pose a danger to children. Never allow children to play with packaging materials. Keep
packaging materials out of reach of children.
•Clean the oil trap aluminum filters regularly. Filters pose risk of fire due to accumulated grease deposits on
them.
•Do not operate your product without filter, and do not remove the filters when the product is in operation. Do
not use non-fire-resistant filtering materials instead of the filter.
•Flammable foods must not be cooked under the appliance.
•In case of any fire, de-energize the device. Cover the flames with a damp cloth or towel. Never use water to put
out the flames.
•Failure to comply with deadlines and periodic instructions may result in a fire hazard.
•This device should not be used by children, persons with physical, sensory or mental abilities, persons lacking
experience or technical knowledge. Do not allow the persons and children under custody to use the product,
play with the product, to perform maintenance and cleaning on the product.
•Kitchen hoods are designed for domestic use. They should not be used for other purposes. May cause various
accidents if used, the device is out of warranty
•The electrical connection of the product must be done to a grounded outlet.
•The electrical connection should only be made once the installation of the appliance has been completed.
•Before the installation, maintenance and cleaning of the product, de-energize the device. (Unplug the device or
turn off the fuse).
•It is forbidden to install the power cord near equipment or materials that may come into contact with heat and
cause distortion. This may cause fire.
•Avoid touching the lamps in your product when they are operating for a long period of time. Since they would
be hot, they could burn your hand.
•Accessible sections may be hot when used with cooking appliances.
•Failure to install screws or fixing installations in accordance with these instructions may result in electrical
hazards.
•Your device is manufactured in accordance with 220-240 V 50 Hz AC AC power supply and requires a fuse of
16 Amp. Should your electrical system differ from these specified values, contact a licensed electrician or your
authorized service center.

5
USER
MANUAL
GENERAL VIEW
Note: Product images are representative. Product may vary in size and model.

6
USER
MANUAL
ACCESSORRIES

7
USER
MANUAL
INSTALLATION
Mounting Distances
Distance between the cooker and the cooker hood must be considered prior to assembly. The distance between
the cooker and the cooker hood should be at least 65 cm.

8
USER
MANUAL
Mounting Instructions
Attach the mounting template to the wall at the distance (65 cm) shown in Figure 1. Drill through points Aand C
with Ø8 mm drill bit. At the Bpoints, drill the chimney mounting plate with a Ø6 mm drill bit, considering the
distance to the ceiling and the maximum length of the flue.
Attach Ø8 mm dowel (5) to points Aand C. Attach Ø6 mm (8) anchors to the Bpoints. Tighten the Ø5 x 50 mm
screw (6) to the Apoints so that the distance between it and the wall is 5 mm. Attach the product body to the
screws at point A and tighten the screws completely. Open the product cover and remove the filters. Complete the
body assembly by mounting Ø5 x 50 mm screws to the Cpoints (6).
Note: The suspension plate mounting shown in detail is optional. It varies based on model.

9
USER
MANUAL
Carbon Filter Assembly
Open the product cover and take out the aluminum filter. (see figure 3) Turn the carbon filter in the direction of the
arrow by pressing the sides. (see Fig. 4)
Flap Assembly
Attach flap tabs to points A as shown in Figure 5. Complete the assembly process so that the nails remain on the
upper surface as shown in Figure 6.
Adapter Mounting
Motor outlet diameter is 150 mm. If a connection with a 120 mm spiral hose be required, the plastic adapter must
be mounted on the body as shown in the figure.
Carbon
Filter
Flap
plastic
Figure 6
Figure 5
Figure 8
Figure 7
150 / 120mm
adapter
Body

10
USER
MANUAL
Flue Installation
Fix the outer flue to the body from point Awith Ø3.5 x 9.5 mm screw. Insert the inner flue into the outer flue and fix
it at the Bpoints with Ø3.5 x 9.5 mm screws.
Air Outlet Connection
Air discharge can be done by flue connection (air discharge to the external environment) or by filtering the air back
to the environment (carbon filter).
Flue Connected Use
For flue-connected use, Ø150 mm or Ø120 mm spiral pipe and clamp must be provided from an authorized service
or service recommended point.
Note: It is recommended to make a pipe connection of Ø150 mm.
The absorbed air is delivered to a flue or outdoor environment with the help of a pipe attached
to the blower motor outlet of the hood in use with flue connection.
WARNING: These parts are not included in the product content and must be purchased.
WARNING: In case of installation connected to a chimney, it is necessary to note all relevant warnings in the
safety and environmental instructions.

11
USER
MANUAL
Flueless use
Touch Control Panel
Lamp: Turns the device lamp on and off. Key lighting is activated when the lamp is on.
1st Speed: The engine of the device runs at speed level 1. Key lightening is activated on while the engine is
running. Pressing this key for a long time activates the timer function and the key lightning flashes. The device is
operated for 15 minutes at first speed level, the motor stops at the end of this period.
2nd Speed: The engine of the device runs at speed level 2. The key illumination of the speed keys lights up when
the engine is running. Pressing this key for a long time activates the timer function. The lighting of the 1st and 2nd
speed keys flashes. The device is operated for 15 minutes at the second speed level, the motor stops at the end of
this period.
3rd Speed: The engine of the device runs at speed level 3. The key illumination of the speed keys lights up when
the engine is running. Pressing this key for a long time activates the timer function and the lightening of the speed
keys flashes. The device is operated for 15 minutes at the third speed level, the motor stops at the end of this
period.
Automatic power-off: Should the appliance be left on, the appliance motor and its lighting are switched off after a
maximum of 5 hours and the lighting lamp after a maximum of 10 hours to ensure safety and energy saving.
The absorbed air is delivered to a flue or outdoor environment with the help of a pipe attached
to the blower motor outlet of the hood in use with flue connection.
WARNING: Since carbon filters are optional parts, they must be purchased from the service at an additional
fee. Never wash the carbon filter.

12
USER
MANUAL
MAINTENANCE AND CLEANING
1. Pay attention to clean the appliance, especially immediately after cooking fried foods.
2. It is sufficient to use a soft cloth soaked in liquid detergent to clean the exterior of the unit.
3. Never use abrasive or scratching products for cleaning.
4. To preserve the surface quality of the unit, avoid using cleaning agents containing methylated spirits, bleach
and abrasive powder when cleaning. On stainless surfaces, use special cleaning spray used for damp, soapy
cloths, or preferably stainless surfaces.
Aluminum Filter Cleaning
The filter helps to keep the oil particles in the air. It is recommended to clean your filter within 1 month for normal
use. Wash and rinse the filters in the dishwasher or in water with liquid detergent and replace after drying.
WARNING: Prior to each maintenance and cleaning, the unit must be unplugged or the fuse to which it is
connected must be disconnected.
WARNING: Without periodic cleaning, there is a risk of fire and loss of yield.
WARNING: When washed in aluminum filters, discoloration can be observed. This is normal, you don't need to
change your filters.
WARNING: If the aluminum filter is not cleaned periodically, the oil accumulated on it creates a risk of fire.

13
USER
MANUAL
Aluminum Filter Removal
EFFICIENT USE OF THE DEVICE
Use 150 / 120 mm diameter pipes and as few elbows as possible when connecting the cooker hood to the
chimney.
Pay attention to the cleaning periods of the metal filters and replacement periods of the carbon filters.
Use the device in the middle stage when it does not require intensive suction power.
TRANSPORT THE DEVICE
Save the original packaging of the device. Transport the device in its original packaging, follow the transport
markings on the packaging.
If the Original Package of the Device Is Not Available.
Avoid putting weight on the device.
Protect the outer surface from impacts.
Carry the device by packing it in such a way that it is not damaged.
Figure 10
Pull the aluminum filter towards you by pressing it down as shown in figure
10. Reverse the process to install the filter.
Note: Avoid bending the aluminum filter to prevent damage.

14
USER
MANUAL
TROUBLESHOOTING
Error Description
Solution
The cooker hood does
not work.
Check the electrical connection.
Check engine switch. The engine switch should be in the on position.
Lightning lamp does
not work
Check the electrical connection.
Check engine switch. Lamp switch must be at "on" position.
Hood draught is weak
Check the aluminum filter Aluminum filter should be washed once a month under
normal conditions.
Check the air outlet flue. The air outlet flue must be open.
Check the carbon filter. (For models with a carbon filter). The carbon filter should be
changed every 3 months under normal conditions.
Does not give air out-
side (in environments
without flues)
Check the aluminum filter Aluminum filter should be washed once a month under
normal conditions.
Check the carbon filter. (For models with a carbon filter). The carbon filter should be
changed every 3 months under normal conditions.

15
USER
MANUAL
Help and Assistance
If you require any technical guidance or find that your Freestanding Cooker is not operating as intended,
a simple solution can often be found in the Troubleshooting section of these instructions or online at
www.creda.co.uk
Ifyou still require further assistance, call one of our experts on 01759 487836. Tohelp give us give you a
fast and efficient service please have the following information ready:
You can find the following on the rating plate - a small information panel (usually a sticker or metal
plate) on the rear of your appliance.
Model Ref.
_________________________________________________________________________________
Serial Number
____________________________________________________________________
Date of Purchase (this will be on your receipt)
__________________________________________________________________________
Local call rates apply*
Lines open 9am-5:30pm Monday to Friday
*Calls to Creda enquiry lines may attract a charge and set up fee from residential lines depending on your call plan/tariff.
Mobile and other providers costs may vary, see www.bt.com/pricing for details.
For Security and training purposes, telephone calls to and from customer service centres maybe recorded and monitored. Calls
from Republic of Ireland will attract international call charges.

16
USER
MANUAL
Call us now and activate your 3 years guarantee
Thank you for choosing Creda. Your new product is guaranteed against faults and
breakdowns for 3 years. Don’t forget to register it with us today so we can provide you
with our best possible after-sales service and useful updates.
www.creda.co.uk
01759 487836
Your Creda Guarantee
This product is guaranteed for 3 years from the date of original purchase. Any defect that arises due to faulty
materials or workmanship will be repaired free of charge (or if applicable the product will be replaced or the
purchase price refunded) where possible during this period by the dealer from who you purchased the unit.
The guarantee is subject to the following provisions:
•The guarantee does not cover accidental damage, misuse, cabinet parts, knobs or consumable
items.
•The product must be correctly installed and operated in accordance with the instructions contained in
the manual.
•It must be used solely for domestic purposes. The guarantee will be rendered invalid if the product is
re-sold or has been damaged by inexpert repair.
•Specifications are subject to change without notice.
•Creda disclaim any liability for loss or damage arising from the breakdown of the product.
•This guarantee is in addition to and does not diminish your statutory or legal rights.
Important Data Protection Information
To find out how we use your data please refer to the guarantee registration material or visit
www.creda.co.uk

17
USER
MANUAL
Declaration of conformance to product standards
This appliance conforms to all relevant standards applicable to domestic appliances sold in
the UK.
Disposal
This appliance/fitting is marked according to the European directive 2012/19/EU on Waste Electrical
and Electronic Equipment (WEEE).
By ensuring this product is disposed of correctly, you will help prevent potential negative
consequences for the environment and human health, which could otherwise be caused by
inappropriate waste handling of this product.
The symbol on the product, or on the documents accompanying the product, the crossed out wheelie
bin symbol, indicates that this appliance/fitting may not be treated as household waste. Instead, it
shall be handed over to the applicable collection point for the recycling of electrical and electronic
equipment.
Disposal must be carried out in accordance with local environmental regulations for waste disposal.
For more detailed information about treatment, recovery, and recycling of this product, please contact
your local authority, your household waste disposal service or the retailer where you purchased the
product.

18
USER
MANUAL
This page is intentionally left blank

19
USER
MANUAL
This page is intentionally left blank

20
USER
MANUAL