Cres Cor 120-PH Series Manual

5925 Heisley Road • Mentor, OH 44060-1833
Call Toll-free: 877-CRES COR (273-7267) • Fax: [phone] • www.crescor.com
Proof/Hot
Cabinets FL-0604
Rev. 20 (3/10) Page 1 of 4
OPERATING and MAINTENANCE INSTRUCTIONS
Models: 120-PH and 121-PH Series Proof/Hot Cabinets
Model No. Volts Watts Amps Hertz Phase NEMA
120-PH-1836
121-PH1816 120 2025 16.8 60 1 5-20P
120-PH1836 240
121-PH-1816 240 240 1925 8 60 1 5-15P
All are designed for AC service.
HOW TO INSTALL UNIT:
Place cabinet near warm ovens. Do1. NOT put in
drafty areas or near ventilating systems.
Plug power cord into proper wall outlet.2. Fill water pan (following steps a-c).3. NOTE: No. 9 setting will give you an approximately
90-95% humidity at 95°F (35°C). Experiment
with different settings to get the exact
temperature and humidity you need.
Thermometer shows the temperature inside the cabinet.
HOW TO PROOF:
Push switch to “HUMIDITY”. Yellow power light1. will come on.
Turn “RESERVOIR THERMOSTAT” to #10. Red2. heater light will come on.
Preheat cabinet for 30 minutes.3. Put fresh or4. fully thawed dough into cabinet.
HOW TO PROOF, continued:
Turn “RESERVOIR THERMOSTAT” to #9 and5. close the door.
CAUTION
NOTE: The cabinet temperature will drop temperature
inside cabinet if cold dough is added.
Do NOT put frozen dough into cabinet
Use of treated or
soft water may be
required for proper
operation and to maintain warranty.
a. Lift off cover.
b. Fill with 3.5 qts. (3.3 liters) of water. Replace cover.
c. Adjust vents on cover to half open.
PARTS IDENTIFICATION
1. Water Pan (Reservoir) 6. Switch: ON/OFF
2. Reservoir Heater & Probe 7. Yellow POWER light; Red
HEATER light for Air
3. Water Pan Cover 8.Air Thermostat
4. Reservoir Thermostat 9.Air Probe
5. Yellow POWER light; Red
HEATER light for Reservoir 10.Air Heater
11. Tunnel Heater

5925 Heisley Road • Mentor, OH 44060-1833
Call Toll-free: 877-CRES COR (273-7267) • Fax: [phone] • www.crescor.com
Proof/Hot
Cabinets FL-0604
Rev. 20 (3/10) Page 2 of 4
OPERATING and MAINTENANCE INSTRUCTIONS
Models: 120-PH and 121-PH Series Proof/Hot Cabinets
Allow cabinet to cool.1.Remove Hot unit from cabinet.2.Do NOT use abrasives or harsh3.chemicals.
WARNING BEFORE cleaning
the cabinet:
HOW TO HEAT CABINET:
Push switch to “AIR”. The1. Red indicator will light.
Turn “AIR THERMOSTAT” to temperature2. needed.
NOTE: No. 8 is approx. 175°F (79°C).
No. 6 is approx. 145°F (63°C).
No. 4 is approx. 115°F (46°C).
Proper food holding temperature is
140°F (60°C) or higher.
Preheat cabinet for 30 minutes.3. Put food into cabinet.4.
DRY PROOFING:
Turn air thermostat to #3 for 100°F (38°C) or higher.
MAINTENANCE
HOT UNIT REMOVAL INSTRUCTIONS:
Unplug power cord from wall outlet.1.
Remove two (2) screws from back of cabinet, one2. (1) above the receptacle and one (1) higher up,
holding the top of the tunnel.
Slide the entire unit out front of the cabinet, tilting3. it to clear the tie rod.
TO TURN UNIT OFF: Push switch OFF.
NOTE: Check water level in water pan if you are
proofing longer than 90 minutes. Fill with
clean, hot water.
Cleaning hints:
Wipe up spills as soon as possible.1.
Clean cabinet regularly to avoid heavy dirt build-up.2.
Make a test spot with cleaner.3. Follow manufacturer’s directions on cleaner.4. Do not mix cleaners.5. Avoid drips and splashes.6.
HOW TO CLEAN THE UNIT:
Soil Cleaner Method
DOOR
(Laminated Vinyl)
DIRT Mild *detergent and water. 1. Wipe with soft, damp cloth.
2. Rinse well.
GREASE and OIL Weak, alcohol-type cleaner. 1. Wipe with soft, damp cloth.
2. Rinse well.
CABINET
(Aluminum)
Inside
and
Outside
DIRT Mild *detergent and hot
water, or mild abrasive
cleaner.
1. Use soft, damp cloth.
2. Rinse with hot water.
3. Wipe dry
Steam (no strong
alkaline additive) 1. Rinse after steam cleaning. 2. Wipe dry.
FINGERPRINTS,
GREASE and OIL Chemical oven cleaner for aluminum Follow oven cleaner manufacturer’s directions.
Mild abrasive cleaner;
oily or waxy cleaner. Apply with soft, clean cloth.
WATER SPOTS Mild abrasive cleaner 1. Apply with damp cloth.
2. Rinse and dry.
*Mild detergents include soaps and non-abrasive cleaners.
FOR HUMIDITY:
Add water to water pan1. Push switch to “HUMIDITY” for a few minutes.2.

5925 Heisley Road • Mentor, OH 44060-1833
Call Toll-free: 877-CRES COR (273-7267) • Fax: [phone] • www.crescor.com
Proof/Hot
Cabinets FL-0604
Rev. 20 (3/10) Page 3 of 4
OPERATING and MAINTENANCE INSTRUCTIONS
Models: 120-PH and 121-PH Series Proof/Hot Cabinets
TROUBLE-SHOOTING CHART:
FAILURE POSSIBLE CAUSE
1. Yellow light does NOT light. 1a. Circuit breaker/fuse to wall outlet is blown.
1b. Cord is unplugged from wall outlet or cabinet.
1c. Switch is “OFF”.
2. Red light does NOT light. 2a. Thermostat turned “OFF”.
2b. Thermostat set too low (light comes on when
heater is on).
3. Unit does not get hot. 3a. Thermostat set too low or is “OFF”.
3b. Water in pan my be low.
3c. Switch is “OFF”.
4. Unit gets too hot or won’t shut off. 4a. Defective electrical parts.
UNPLUG UNIT FROM WALL OUTLET.
5. Humidity is low 5a. Water in pan may be low
5b. Thermostat set too low
If cause is none of the above, refer to our list of Authorized Service Centers, FL-1400.
Instructions for replacing parts are included with the replacement parts kits.
CAUTION DELIME OR DESCALE RESERVOIR PARTS AS REQUIRED
TO PREVENT DAMAGING BUILD-UP.
WARRANTY COVERAGE MAY BE AFFECTED WITHOUT PROPER CLEANING.
REPLACEMENT PARTS:
Description 120 Volt 240 Volt
Proof/Hot Unit...........................................PHU-18-747-18....................PHU-18-747-19
Water Pan w/Heater...................................0756-014...............................0756-015
Water Pan Cover........................................1245-001...............................1245-001
Heater (Water Pan) 1000W........................0811-005-K
Heater (Water Pan) 900W.........................................................................0811-015K
Heater (Tunnel)..........................................0811-075...............................0811-078
Latch, Door................................................1136-K..................................1136-K
Power Cord Kit..........................................0810-093...............................0810-039
Power Light (Yellow)................................0766-048............................... 0766-045
Power Light (Red).....................................0766-047...............................0766-046
Relay..........................................................0857-097...............................0857-098
Switch Kit..................................................0808-082...............................0808-010
Strain Relief Collar....................................5459-004-03.......................... 5459-004-1
Terminal Block..........................................0978-007-K...........................0978-007-K
Thermostat Kit...........................................0848-062-K...........................0848-062-K
Thermometer Kit.......................................5238-018-K...........................5238-018-K

5925 Heisley Road • Mentor, OH 44060-1833
Call Toll-free: 877-CRES COR (273-7267) • Fax: [phone] • www.crescor.com
Proof/Hot
Cabinets FL-0604
Rev. 20 (3/10) Page 4 of 4
OPERATING and MAINTENANCE INSTRUCTIONS
Models: 120-PH and 121-PH Series Proof/Hot Cabinets
PL3 PL4
6-15P
20
2
H4
G
1
TB
27
2
23 12
TH2
AA
6
20
17
H1
21
H3
26
26
R
16
24
7
5
1
12
29
29
10
23
1
28
PL2 PL1
19
20
2
SW.
2
27
10
16
R
10
5
5
TH1
W
G
5-20P
TB
RA
PL2 PL1
AR
PL3 PL4
SW.
2
2
6
7
H4
H1
H3
1
1
1
12
12
26
26
23
28
24
21
17
10
29
9
10
10
55
5
27
27
29
16
16
6
TH1
TH2
23 12
WIRING DIAGRAMS
ELECTRICAL SPECS.
MODEL #0747-018
110/120V, 2025 W,
1Ph, 50/60Hz, AC Service
ELECTRICAL SPECS.
MODEL #0747-019
220/240V, 1925 W,
1Ph, 50/60Hz, AC Service
LEGEND
H4 HEATER-TUNNEL
H1 HEATERS-AIR
H3 HEATER-RESERVOIR
PL1 PILOT LIGHT, RESERVOIR-AMBER
PL2 PILOT LIGHT, RESERVOIR-RED
PL3 PILOT LIGHT, AIR-AMBER
PL4 PILOT LIGHT-AIR-RED
SW SWITCH
TB TERMINAL BLOCK
TH1 THERMOSTAT-AIR
TH2 THERMOSTAT-RESERVOIR
5-20P FLANGED INLET 120V, 20A
SLEEVING
WIRENUT
LEGEND
H4 HEATER-TUNNEL
H1 HEATERS-AIR
H3 HEATER-RESERVOIR
PL1 PILOT LIGHT, RESERVOIR-AMBER
PL2 PILOT LIGHT, RESERVOIR-RED
PL3 PILOT LIGHT, AIR-AMBER
PL4 PILOT LIGHT-AIR-RED
SW SWITCH
TB TERMINAL BLOCK
TH1 THERMOSTAT-AIR
TH2 THERMOSTAT-RESERVOIR
5-20P FLANGED INLET 120V, 20A
SLEEVING
WIRENUT